Joining Wireless Networks

Universal WiFi Range Extender WN3000RP


-	The best performance is delivered when both the Link Rate LED			and the PC to
	Extender Connection LED	are green.
-	A workable performance is delivered when the Link Rate LED is amber				and the
	PC to Extender Connection LED		is green.

If you cannot get a wireless connection working, you can use an Ethernet cable to connect your computer to the Extender. See Connect a PC to the Extender with an Ethernet Cable on page 8.

To join a wireless network you must know its network name (also called the SSID) so that you can select it. If the network is secure, you must know the passphrase or wireless key. If the Extender does not connect to the network that you chose, the following message displays:

Connection was not established to the selected network.

If this happens it could be due to one of these reasons:

•The network name, passphrase, or key might have been typed incorrectly. Click Cancel, use the Smart Wizard to select the network from the list, and retype the passphrase or key. This is case-sensitive. PASSWORD25 is not the same as Password25 or password25. See Use the Smart Wizard to Set Up the Extender on page 9.

•If the Smart Wizard does not find your wireless network (it is not displayed in the Select Existing Network screen), check to see if your wireless network is still up and running. Make sure that the router is turned on. If possible, move the Extender closer to the router and click Try Again.

•If the Extender WLAN LED is red, this indicates a poor wireless connection. The best connection is established when there is a clear line of sight between the Extender and the router you are connecting to. Make sure that there are no physical obstacles between the Extender and the router, and try to move the Extender closer to the router.

If you use the Smart Wizard, and the Extender cannot connect to the router or cannot get an IP address from the router, it displays the following message:

You are not able to connect to the Internet. Click Continue to run through set up again to connect to your network.

If you click Continue, the Smart Wizard starts again (see Use the Smart Wizard to Set Up the Extender on page 9). If you click Exit, the Status screen displays with menu selections on the left (see Log In to the Extender on page 8).

Troubleshooting