R6300v2 Smart WiFi Router
5.Click the Add button.
The screen changes back to the list screen.
6.Add each computer or device you want to allow to connect wirelessly.
7.Select the Turn Access Control On check box.
8.Click the Apply button.
To edit a wireless device or delete it from the access list:
1.Select ADVANCED > Advanced Setup > Wireless Settings. The Advanced Wireless Settings screen displays.
2.In the table, select the radio button next to the wireless device that you want to edit or delete.
3.Do one of the following:
•Click the Edit button.
The Edit Wireless Card screen displays.
a.Edit the address information.
b.Click the Accept button.
•Click the Delete button.
The address is removed from the table.
Wireless Access Point (AP)
You can set up the router to run as an access point (AP) on the same local network as another router.
Note: To avoid interference with other routers or gateways in your network, NETGEAR recommends that you use different wireless settings on the router in access point mode. You can also turn off the wireless radio on the other router or gateway.
To set up the router as an AP:
1.Connect an Ethernet cable to the Internet port of this router and to a LAN port in the other router.
Cable this port to a LAN port on the other router
Advanced Settings
94