D-Link DIR-301 manual Big Pond

Page 23

Section 3 - Configuration

Internet Setup

Big Pond

User Name: Enter your Big Pond user name.

Password: Enter your Big Pond password and then retype the password in the next box.

Auth Server: Enter the IP address of the login server.

Login Server IP: Enter the IP address of the login server.

MAC Address: The default MAC Address is set to the WAN’s physical interface MAC address on the Broadband Router. It is not recommended that you change the default MAC address unless required by your ISP.

Clone MAC The default MAC address is set to the WAN’s Address: physical interface MAC address on the Broadband Router. You can use the “Clone MAC Address” button to copy the MAC address of the Ethernet Card installed by your ISP and replace the WAN MAC address with the MAC address of the router. It is not recommended that you change the default MAC address

unless required by your ISP.

D-Link DIR-301 User Manual

23

Image 23
Contents Page Table of Contents Registration Wireless SecurityTroubleshooting Wireless Basics Networking BasicsProductPackageOverviewContents Introduction Features LAN Ports Hardware OverviewConnections Status LED Power LEDLEDs Local Network LEDsBefore you Begin InstallationWireless Installation Considerations Connect to Cable/DSL/Satellite Modem Connect to Another Router Installation Web-based Configuration Utility ConfigurationClick Launch Internet Connection Setup Wizard to begin Setup WizardConfiguration Configuration Configuration Dynamic Cable Internet SetupPPPoE DSL Pptp L2TP Big Pond Static assigned by ISP Wireless Settings Network Settings Dhcp Server Settings Port Forwarding Rules Application Rules Dhcp Client Network FilterWebsite Filter Configure Website Select Turn Website Filtering OFF, TurnFirewall Settings CTS Mode Advanced Wireless SettingsAdvanced Network Settings IP Address Port Administrator SettingsTime Settings System Settings Firmware Upgrade System Check Device Information Log Stats Wireless StatsSupport What is WEP? Wireless SecurityNext to Security Mode, select Enable WEP Security Configure WEPWhat is WPA? Configure WPA-PSK Configure WPA Radius Using Windows XP Connect to a Wireless NetworkConfigure WEP Connecting to a Wireless Network Configure WPA-PSK Connecting to a Wireless Network Why can’t I access the web-based configuration utility? TroubleshootingWhat can I do if I forgot my password? Troubleshooting Troubleshooting Wireless Basics Wireless Local Area Network Wlan What is Wireless?Small Office and Home Office Wireless Personal Area Network WpanHome Eliminate Interference Centralize your router or Access PointSecurity Wireless ModesCheck your IP address Networking BasicsStep Highlight Internet Protocol TCP/IP and click Properties StepStandards Technical SpecificationsHumidity Contacting Technical Support