Instant WirelessTM Series
The Wireless Presentation Gateway’s LEDs
Figure
Power Red. The Power LED will light up when the Wireless Presentation Gateway is powered on.
WLAN Act Green. The WLAN Act LED blinks when the Wireless Presentation Gateway is active.
WLAN Link Yellow. The WLAN Link LED indicates the status of the link. The WLAN Link LED will be lit steadily when the Wireless Presentation Gateway is connected to the wireless network.
Note: As with any video system, image quality is only as good as the weakest link in the video signal chain. In most cases, that weakest link is the infrastructure cable. This especially holds true for wireless transmission systems. To achieve the best possible image quality with a wireless system, dedicate as much bandwidth as possible to the video presentation.
Wireless Presentation Gateway
Chapter 3: Connecting the Wireless Presentation Gateway
1.Connect the serial cable, connected to your monitor or projector, to the Wireless Presentation Gateway’s “TO Monitor/Projector” console port.
2.Plug the supplied power adapter into the jack on the Wireless Presentation Gateway’s back panel. Then, plug the other end into a power outlet.
3.Proceed to Chapter 4: The Wireless Presentation Gateway’s Player.
The installation is complete.
4 | 5 |