R.H.
Mandrel T
Cover
Elecltic
Pulley
Idler
Pulleys
Mandrel
Suspension Primary
ArmArm
TO REPLACE MOWER BLADE DRIVE BELT
Park the tractor on level surface. Engage parking brake.
1.Remove mower drive belt (See "TO REPLACE MOWER DRIVE BELT" in
this section of this manual).
2.Remove mower (See "TO REMOVE MOWER" in this section of this
manual).
3.Remove screws from L.H. mandrel cover and remove cover.
4.Carefully roll belt off L.H. mandrel pulley.
5.Remove belt from center mandrel pulley, idler pulley, and R.H. mandrel pulley.
6.Remove any dirt or grass which may have accumulated around mandrels
and entire upper deck surface.
7.Check secondary idler arm and idler pulley to see that they rotate freely.
8.Be sure spring is hooked in secondary idler arm and secondary spring arm.
9.Install new belt in lower groove of R.H. mandrel pulley, idler pulley, and
center mandrel pulley as shown. 10.Carefully roll belt over L.H. mandrel
pulley. Make sure belt is in all grooves properly.
11.Reinstall L.H. mandrel cover.
12.Reinstall mower to tractor (See
"INSTALL MOWER AND DRIVE
BELT" in the Assembly section of this manual).
13.Reassemble mower drive belt (See
"TO REPLACE MOWER DRIVE BELT"
in this section of this manual).
L.H. | Secondary | Idler |
Idler Arm | Pulley Spring | |
Mandrel |
| |
|
| Secondary |
|
| Spring Arm |
|
| Center |
|
| Mandrel |
R.H.
Mandrel
TO ADJUST ATTACHMENT CLUTCH
The electric clutch should provide years of service. The clutch has a
that stops the pulley within 5 seconds. Eventually, the internal brake will wear which may cause the mower blades to
not engage, or, to not stop as required. Adjustments should be made by a Sears or other qualified service center.
1.Make sure attachment clutch and ignition switches are in =OFF" position.
2.Adjust the three nylon Iocknuts until space between clutch plate and rotor measures .012" at all three slot locations cut in the side of brake plate.
26
