Craftsman 917.275021 manual T.O Transport

Models: 917.275021

1 64
Download 64 pages 44.42 Kb
Page 17
Image 17
T.O TRANSPORT

T.O TRANSPORT

When pushing or towing your tractor, be sure to disengage transmission by placing freewheel control in freewheeling position. Free wheel control is located at the rear drawbar of tractor.

1.Raise attachment lift to highest position with attachment lift control.

2.Pull freewheel control out and into the

slot and release so it is held in the disengaged position.

Do not push or tow tractor at more than two (2) MPH.

To reengage transmission, reverse above procedure.

NOTE: To protect hood from damage when transporting your tractor on a truck or a trailer, be sure hood is closed and secured to tractor. Use an appropriate means of tying hood to tractor (rope, cord, etc.).

TOWING CARTS AND OTHER ATTACH- MENTS

Tow only the attachments that are recommended by and comply with specifications of the manufacturer of your

tractor. Use common sense when towing. Too heavy of a load, while on a slope, is dangerous. Tires can lose traction with

the ground and cause you to lose control of your tractor.

BEFORE STARTING THE ENGINE CHECK ENGINE OIL LEVEL

The engine in your tractor has been shipped, from the factory, already filled with summer weight oil.

1.Check engine oil with tractor on level ground.

2.Unthread and remove oil fill cap/ dipstick; wipe oil off. Reinsert the dipstick into the tube and rest oil fill

cap on the tube. Do not thread the cap onto the tube. Remove and read

oil level. If necessary, add oil until

=FULL" mark on dipstick is reached.

Do not overfill.

For cold weather operation you should

change oil for easier starting (See =OIL

VISCOSITY CHART" in the Mainte- nanca section of this manual).

To change engine oil, see the Mainte- nance section in this manual.

ADD GASOLINE

Fill fuel tank. Use fresh, clean, regular unleaded gasoline with a minimum of

87 octane. (Use of leaded gasoline will increase carbon and lead oxide

deposits and reduce valve life). Do not mix oil with gasoline. Purchase fuel in quantities that can be used within 30 days to assure fuel freshness.

IMPORTANT: When operating in temperatures below 32°F(0°C), use fresh, clean winter grade gasoline to help insure good cold weather starting.

_WARNING: Experience indicates that alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids dudng storage. Acidic gas can damage the fuel system of an

engine while in storage. To avoid engine problems, the fuel system should be

emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions for additional information. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

I,CAUTION: Fill to bottom of gas tank filler neck. Do not overfill. Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

TO START ENGINE

When starting the engine for the first time or if the engine has run out of fuel, itwill take extra

crankincj_me to move fuel from the tank to the eng=ne.

1.Be sure freewheel control is in the transmission engaged position.

2.Sit on seat in operating position,

depress brake pedal and set parking brake.

3.Move attachment clutch to "DISEN-

GAGED" position.

4.Move throttle control to fast position

5.Pull choke control out for a cold

engine start attempt. For a warm engine start attempt the choke control may not be needed.

17

Page 17
Image 17
Craftsman 917.275021 manual T.O Transport