The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye damage• Always wear safety glasses or eye shields while operating your tractor or performing any adjustments or repairs. We recommend a wide vision safety mask over spectacles or standard safety glasses.

HOWTO USEYOURTRACTOR

 

 

Never

use choke to stop engine.

TO SET PARKING

BRAKE

 

 

IMPORTANT:

Leaving the ignition switch

Your tractor is equipped with an operator

in any position other than "OFF" will

cause the battery to be discharged,

presence sensing switch. When engine

(dead).

 

 

 

 

 

 

is running, any attempt by the operator to

 

 

 

 

 

 

NOTE: Under certain conditions when

leave the seat without first setting the

tractor is standing idle with the engine

parking brake will shut off the engine.

running, hot engine exhaust gases may

1. Depress brake pedal into full =BRAKE"

cause "browning" of grass. To eliminate

 

position

and

hold.

 

 

 

 

 

 

 

 

 

 

 

this possibility, always stop engine when

2. Place parking brake lever in "EN-

stopping tractor on grass areas.

 

 

GAGED"

position and release

 

 

 

 

 

 

 

 

 

 

 

 

 

pressure from

brake

pedal.

Pedal

,_CAUTION:

 

Always stop tractor

 

should remain

in "BRAKE"

position.

completely, as described above, before

 

Make sure parking brake will hold

leaving the operator's position; to empty

 

tractor secure.

 

 

 

 

 

 

 

 

 

 

 

 

 

grass catcher,

etc.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Push-In to

 

 

Attachment Clutch

TO USE THROTTLE

CONTROL

 

 

Choke ___=Disengage" Switch Pull Out to

 

 

Always

operate

engine at full throttle.

 

Control,

_,,

 

 

 

 

 

 

Engage"

 

 

 

 

 

 

 

 

 

 

 

 

Operating engine at less than full

 

 

 

 

 

 

 

 

 

 

 

 

 

throttle reduces the battery charging

 

 

 

 

 

 

 

 

 

 

 

 

 

rate.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Full throttle

offers the best mower

Brake-_

 

/

_'_/_

_

....... __

J

 

performance.

 

 

 

Pedal

 

_

 

 

r

 

__U_

_

v

TO USE CHOKE

CONTROL

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

_/

_

Height _f

 

 

_,

Motion

"_

Use choke control whenever you are

 

 

 

starting

a cold engine. Do not usa to start

 

 

 

 

 

 

 

\

Control Lever

 

_---'-

 

Adjustment

 

 

Brake

a warm

engine.

 

 

 

 

 

Knob

 

 

 

"Parking

• To engage choke control, pull knob out.

Brake Pedal

 

 

 

 

"Engaged" Position

 

 

 

 

 

Slowly push knob in to disengage.

"Drive" Position

=Disengaged" Position

 

TO MOVE FORWARD

AND

 

STOPPING

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

BACKWARD

 

 

 

 

 

MOWER

 

BLADES -

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

A(_,CAUTION: Do not attempt to operate

To stop mower

 

blades,move

attach-

 

motion control lever when the parking

 

ment clutch switch to "DISENGAGED"

brake is set or when

the brake

pedal is

 

position.

 

 

 

 

 

 

 

 

depressed.

Doing so may result in

GROUND

DRIVE

 

-

 

 

 

 

 

misadjustment

to the drive control system.

To stop ground drive, depress brake

The direction and speed of movement is

controlled by the motion control lever.

 

pedal into full "BRAKE" position.

 

1. Start tractor with motion control lever

IMPORTANT: The motion control lever

 

in neutral

(N)

position.

 

returns to neutral (N) position when the

 

 

2.

Release

parking

brake.

 

brake pedal is fully depressed.

 

 

 

 

 

3. Slowly move motion control lever to

ENGINE

 

-

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

desired

position•

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Move

throttle control to slow position•

TO ADJUST

MOWER

CUTTING

HEIGHT

NOTE: Failure to move throttle control to

The cutting height is controlled by turning

slow position and allowing engine to idle

the height adjustment knob in desired

before stopping may cause engine to

direction.

 

 

 

 

 

"backfire".

 

 

 

 

 

 

 

 

 

Turn knob clockwise (F_I) to raise

Turn ignition key to "OFF* position and

 

cutting height.

 

 

 

 

remove key. Always remove key when

 

 

 

 

 

Turn knob counterclockwise (P-'_) to

 

leaving tractor to prevent unauthorized

 

 

lower

cutting height.

 

 

use.

 

 

 

 

 

 

 

 

 

 

15

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Page 15
Image 15
Craftsman 917.275021 manual Howto Useyourtractor