Linksys AG241 manual Getting to Know the ADSL2 Gateway with 4- Port Switch, Line

ADSL2 Gateway with 4-Port Switch

Chapter 3: Getting to Know the ADSL2 Gateway with 4- Port Switch

The Back Panel

Figure 3-1: Back Panel

The Gateway’s ports, where a network cable is connected, are located on the back panel. The Gateway’s buttons are also located on the back panel.

LINE The LINE port connects to the ADSL line.

Ethernet (1-4) The Ethernet ports connect to your computer and other network devices.

Reset Button There are two ways to Reset the Gateway's factory defaults. Either press the Reset Button, for approximately ten seconds, or restore the defaults from the Factory Defaults screen of the Administration tab in the Gateway’s Web-Based Utility.

Power The Power port is where you will connect the power adapter.

On/Off Switch This switch is used to turn the Gateway on or off.

With these, and many other, Linksys products, your networking options are limitless. Go to the Linksys international website at www.linksys.com/international for more information about products that work with the Gateway.

Important: Resetting the Gateway to factory defaults will erase all of your settings

and replace them with the factory defaults. Do not reset the Gateway if you want to retain these settings.

Chapter 3: Getting to Know the ADSL2 Gateway with 4-Port Switch 8

The Back Panel