NETGEAR appendix Reference Manual for the Adsl Modem Wireless Router DG834GSP

Page 18

Reference Manual for the ADSL Modem Wireless Router DG834GSP

Step 2: Configuring the NETGEAR ProSafe VPN Client on the Remote PC at the Telecommuter’s Home Office

This procedure describes how to configure the 54 Mbps ADSL Modem Wireless Router Model DG834GSP. We will assume the PC running the client has a dynamically assigned IP address.

The PC must have a VPN client program installed that supports IPSec (in this case study, the NETGEAR VPN ProSafe Client is used). Go to the NETGEAR website (http://www.netgear.com) and select VPN01L_VPN05L in the Product Quick Find drop-down menu for information on how to purchase the NETGEAR ProSafe VPN Client.

Note: Before installing the 54 Mbps ADSL Modem Wireless Router Model DG834GSP software, be sure to turn off any virus protection or firewall software you may be

running on your PC.

1.Install the NETGEA ProSafe VPN Client on the remote PC and reboot.

a.You may need to insert your Windows CD to complete the installation.

b.If you do not have a modem or dial-up adapter installed in your PC, you may see the warning message stating “The NETGEAR ProSafe VPN Component requires at least one dial-up adapter be installed.” You can disregard this message.

c.Install the IPSec Component. You may have the option to install either the VPN Adapter or the IPSec Component or both. The VPN Adapter is not necessary.

d.The system should show the ProSafe icon () in the system tray after rebooting.

e.Double-click the system tray icon to open the Security Policy Editor.

2.Add a new connection.

a.Run the NETGEAR ProSafe Security Policy Editor program and create a VPN Connection.

B-18

NETGEAR VPN Configuration

v1.0, June 2007

Page 17 Page 19
Image 18
Page 17 Page 19
Contents Appendix B Netgear VPN Configuration Configuration ProfileSee How to Set Up a Gateway-to Step-ByClick VPN Policies under Advanced VPN to invoke this screen Reference Manual for the Adsl Modem Wireless Router DG834GSP Click IKE Policies under VPN to invoke this screen DG834GSP with Fqdn to FVL328 PC/Client-to-Gateway Step-By-Step Configuration Use of a Fully Qualified Domain Name FqdnCheck the box Use a Dynamic DNS Service Figure B-6Figure B-8 Figure B-9 Device LAN IP Address LAN Subnet Mask Figure B-11 Configuration Summary Telecommuter Example Reference Manual for the Adsl Modem Wireless Router DG834GSP 255.255.255.0 Single address Main Mode Fully Qualified Domain NameSubnet address 3600Click Apply when done to get the VPN Policies screen Reference Manual for the Adsl Modem Wireless Router DG834GSP Figure B-15 Select the Connect using Secure Gateway Tunnel check box Figure B-16Figure B-17 Figure B-18 Configure the VPN Client Authentication Proposal Figure B-19Authentication Method menu, select Pre-Shared key Figure B-20Check the Encapsulation Protocol ESP checkbox Check the VPN ConnectionFigure B-22 Type ping -t 10.1.1.1, and then click OK Monitoring the VPN Tunnel Telecommuter Example Viewing the PC Client’s Connection Monitor and Log ViewerViewing the VPN Router’s VPN Status and Log Information Figure B-26Figure B-27 Reference Manual for the Adsl Modem Wireless Router DG834GSP Reference Manual for the Adsl Modem Wireless Router DG834GSP
Top Page Image Contents