NETGEAR appendix DG834GSP with Fqdn to FVL328

Page 6

Reference Manual for the ADSL Modem Wireless Router DG834GSP

3.Test the VPN tunnel by pinging the remote network from a PC attached to the DG834GSP.

a.Open the command prompt (Start -> Run -> cmd)

b.ping 172.23.9.1

Figure B-4

Note: The pings may fail the first time. If this happens, try the pings a second time.

DG834GSP with FQDN to FVL328

This appendix is a case study on how to configure a VPN tunnel from a NETGEAR DG834GSP to a FVL328 using a Fully Qualified Domain Name (FQDN) to resolve the public address of one or both routers. This case study follows the VPN Consortium interoperability profile guidelines (found at http://www.vpnc.org/InteropProfiles/Interop-01.html).

Configuration Profile

The configuration in this document follows the addressing and configuration mechanics defined by the VPN Consortium. Gather all the necessary information before you begin the configuration process. Verify whether the firmware is up to date, all of the addresses that will be necessary, and all of the parameters that need to be set on both sides. Check that there are no firewall restrictions.

B-6	NETGEAR VPN Configuration

v1.0, June 2007

Image 6

Contents Appendix B Netgear VPN Configuration Configuration ProfileSee How to Set Up a Gateway-to Step-ByClick VPN Policies under Advanced VPN to invoke this screen Reference Manual for the Adsl Modem Wireless Router DG834GSP Click IKE Policies under VPN to invoke this screen DG834GSP with Fqdn to FVL328 PC/Client-to-Gateway Step-By-Step Configuration Use of a Fully Qualified Domain Name FqdnCheck the box Use a Dynamic DNS Service Figure B-6Figure B-8 Figure B-9 Device LAN IP Address LAN Subnet Mask Figure B-11 Configuration Summary Telecommuter Example Reference Manual for the Adsl Modem Wireless Router DG834GSP 255.255.255.0 Single address Main Mode Fully Qualified Domain NameSubnet address 3600Click Apply when done to get the VPN Policies screen Reference Manual for the Adsl Modem Wireless Router DG834GSP Figure B-15 Select the Connect using Secure Gateway Tunnel check box Figure B-16Figure B-17 Figure B-18 Configure the VPN Client Authentication Proposal Figure B-19Authentication Method menu, select Pre-Shared key Figure B-20Check the Encapsulation Protocol ESP checkbox Check the VPN ConnectionFigure B-22 Type ping -t 10.1.1.1, and then click OK Monitoring the VPN Tunnel Telecommuter Example Viewing the PC Client’s Connection Monitor and Log ViewerViewing the VPN Router’s VPN Status and Log Information Figure B-26Figure B-27 Reference Manual for the Adsl Modem Wireless Router DG834GSP Reference Manual for the Adsl Modem Wireless Router DG834GSP