NETGEAR DG834GV manual Adsl Modem Wireless Router’s Front Panel, LED Descriptions

Page 6

Setup Manual for the DG834GV Integrated ADSL Modem and Wireless Router with Voice

The ADSL Modem Wireless Router’s Front Panel

The ADSL modem wireless router front panel shown below contains status LEDs.

1

2

3

4

5

6

7

Figure 1-1

You can use the LEDs to verify various conditions. Table 1-1describes each LED.

Table 1-1.

LED Descriptions

 

 

 

Label

Activity

Description

 

 

 

 

 

 

On (Green)

Power is supplied to the router.

1.

Power

On (Red)

Power-on Self-test failure or device malfunction.

 

 

Off

Power is not supplied to the router.

 

 

On (Amber)

System is not ready or failed to start up.

2.

Test

Blink (Amber)

The system is initializing.

 

 

Off

The system is ready and running.

 

 

On (Green)

ADSL is synchronized.

3.

ADSL

Blink (Green)

DSL is attempting to synchronize.

 

 

Off

No link is detected on this port or modem is not powered on.

 

 

On (Green)

Internet port is connected, has an IP address, DSL is up, no traffic detected.

4.

Internet

Flicker (Green)

Traffic is passing through the connected internet port in either direction.

Red

Device attempted to connect, but failed.

 

 

 

 

Off

Modem powered off or in bridged mode, or ADSL connection not present.

 

 

 

 

1-2

 

 

Connecting the Router to the Internet

v1.0, February 2006

Image 6
Contents NETGEAR, Inc Trademarks Contents Troubleshooting Internet Browsing Chapter Connecting the Router to the Internet What’s in the Box?Adsl Modem Wireless Router’s Front Panel LED DescriptionsAdsl Modem Wireless Router’s Rear Panel V1.0, February Two Setup Methods 1 Smart Wizard Setup 2 Manual Setup Internet Configuration RequirementsWhat You Need Before You Begin Smart Wizard Setup Manual Setup Understanding Adsl MicrofiltersManually Setting Up Your Adsl Modem Wireless Router Computers Set to DhcpV1.0, February Phone Port V1.0, February V1.0, February V1.0, February How to Manually Set Up and Test Basic Wireless Connectivity Implement Appropriate Wireless Security V1.0, February Chapter Troubleshooting Basic FunctioningPower LED Not On Test LED Never Turns On or Test LED Stays OnTroubleshooting the Web Configuration Interface LAN or Adsl Internet Port LEDs Not OnTroubleshooting the ISP Connection Adsl linkObtaining an Internet IP Address Adsl Internet LED OffTroubleshooting PPPoE or PPPoA Troubleshooting a TCP/IP Network Using the Ping Utility Troubleshooting Internet BrowsingTesting the LAN Path to Your Router Testing the Path from Your Computer to a Remote Device Request timed outRestoring the Default Configuration and Password Using the Reset ButtonV1.0, February Appendix a Technical Specifications Network Protocol and Standards CompatibilityV1.0, February Appendix B Related Documents Document LinkV1.0, February
Related manuals
Manual 34 pages 4.64 Kb