Actiontec electronic GT701WG-QW04 Line Port, Phone Port, USB Port, Ethernet Port, Reset Switch

Page 9

Actiontec DSL Modem User Manual

Rear Panel

The rear panel of the Modem contains five ports (Line, Phone, USB, Ethernet, and Power), as well as a Reset switch.

Power

Reset

Ethernet

USB

Phone

Line

Line Port

Used to connect the Modem to a DSL (Digital Subscriber Line) connection.

Phone Port

Used to connect a telephone to the Modem.

USB Port

Used to connect a computer to the Modem via USB cable.

Ethernet Port

Used to connect computers to the Modem via Ethernet cable. The Ethernet port is a 10/100 Mbps port; a straight-through Ethernet cable must be used when connecting to the port.

Reset Switch

Depressing the Reset Switch for one or two seconds will power cycle (similar to unplugging and then plugging in the Modem’s power cord) the Modem. To restore the Modem’s factory default settings, depress and hold the Reset Switch for approximately 10 seconds. The reset process will start about 10 seconds after releasing the Reset Switch, or until the Power light glows amber.

4

Image 9

Contents DSL Modem Table of Contents Troubleshooting Reference Using UtilitiesSpecifications Glossary Firewall Security Level Services105 Limited Warranty 107This page left intentionally blank Package Contents Introduction1Minimum System Requirements Features Wireless Light Power LightDSL Light Internet LightLine Port Reset SwitchPhone Port USB PortUsed to connect the Power Cord to the Modem Power PortOther Problems DSL service outage support and repairWired/Wireless Upgrade DSL service installation support Advanced Feature SupportIntroduction This page left intentionally blank Using Qwest DSL Connecting to the InternetDisconnecting from the Internet This page left intentionally blank Performing a Basic Setup Basic SetupTo configure the Modem for basic operation Page Changing the User Name and Password Click Save and Restart at the bottom of the screen Setting Up Static IP Address Configuring for a Single Static IP AddressTo set up the Modem to use a single static IP address Page Setting Up Static IP Page Click Save and Restart at the bottom of the screen To set up the Modem to use a block of static IP addresses Configuring for a Block of Static IP AddressesSetting Up Static IP Page Click Save and Restart from the menu on the left side Dhcp Server Configuration screen, select Static fromClick Save and Restart at the bottom of the screen Accessing Advanced Settings Configuring5 Advanced SettingsWAN IP Address Transparent Bridging PPP Auto Connect Save & Apply Encapsulation PPPoA onlySpecify a Static IP Address Wireless Settings Off ChannelWEP WEP+802.1x WPA Wireless Advanced Settings Wireless MAC AuthenticationDhcp Server Beginning IP Address, Ending IP Address Dhcp Server ConfigurationDNS Dynamic or Static DNS ServerServices Blocking Remote Management/Telnet Website BlockingTo remove forwarded ports, highlight them, then click Remove Port ForwardingClicking Advanced brings up the Advanced Port Forward screen DMZ HostingDynamic Routing FirewallStatic Routing NAT Network Address TranslationIP QoS Setting Source LAN IP Address Telnet Timeout SettingThis page left intentionally blank Accessing Status To access the Status screens, follow these instructionsViewing Modem’s Status Current Status Viewing the Modem’s Status WAN Status Dhcp User List LAN StatusPage Web Activity Log Using UtilitiesDSL Settings Upgrade Firmware Restore Default SettingsThis page left intentionally blank Troubleshooting LAN Connection FailureCannot Connect to the Internet CMD Time out error occurs when entering a URL or IP Address This page left intentionally blank Locating Computer Information ReferenceLocating Windows Operating System Files Appendix a Reference Click Search Windows 98 SE Static IP Address On the ComputerPage 192.168.0.2 Enter the following numbers in the Subnet mask text box Windows MeAppendix b Static IP on the Computer Do not include the periods they are automatically entered Windows Page Appendix b Static IP on the Computer Enter the following numbers in the IP Address text box Windows XP Page Appendix b Static IP on the Computer Enter the following address in the IP Address text box Computer Security Comparing DSL Service with a Dial-Up ModemModem Security Computer SecurityInternet Browsers Electronic Security This page left intentionally blank General Specifications dWAN PPP, DHCP, Static IP Full-rate Adsl InterfaceLED Indicators Wireless Operating RangePower, DSL, Internet, Ethernet, USB, Wireless EnvironmentalGlossary Access PointPage Ssid This page left intentionally blank Firewall Security Level Services Medium Security Level Low Security Level Service Acronym Definitions Icmp Real audio/video323 120Classic Alternativeg System SetupPage Appendix g Alternative System Setup Then press Enter on the keyboard Connecting to the ISPAppendix g Alternative System Setup 100 Additional Technical Support Options Basic Setup Support Getting OnlineSelf Help QwestNetworking LAN Support Advanced Feature SupportAppendix h Additional Technical Support Options 104 Regulatory Compliance Notices ModificationsClass B Equipment All other names are the property of their respective owners Miscellaneous Legal Notices107 Limited Warranty108 Limited Warranty 110