Actiontec electronic 56K user manual

Page 32

areas, the total REN of devices connected to a line should not exceed five (5.0). To find out the total permitted in your area, contact your local telephone company.

If your telephone equipment causes harm to the telephone network, the telephone company can discontinue your service temporarily. If possible, the company will notify you in advance. But if advance notice isn’t practical, you will be notified as soon as possible. You will be informed of your right to file a complaint with the FCC.

Your telephone company can make changes in its facilities, equipment, operations, or procedures that could affect the operation of your equipment. If so, you will be notified in advance so you can make the changes needed to maintain uninterrupted service.

If you experience trouble with this equipment, please contact the manufacturer at the address given in this manual. The telephone company may ask that you disconnect this equipment from the network until the problem has been corrected or until you are sure that the equipment in is not malfunctioning.

Canadian Department Of Communications (CDOC) Certification Label

NOTICE: The Canadian Department of Communications label identifies certified equipment. This certification means that the equipment meets certain telecommuni- cations network protective, operational, and safety requirements. The Department does not guarantee the equipment will operate to the user’s satisfaction.

Before installing this equipment, users should ensure that it is permissible to be con- nected to the facilities of the local telecommunications company. The equipment must also be installed using an acceptable method of connection. In some cases, the company’s inside wiring associated with a single line individual service may be ex- tended by means of a certified connector assembly (telephone extension cord). The customer should be aware that compliance with the above conditions may not pre- vent degradation of service in some situations.

Repairs to certified equipment should be made by an authorized Canadian mainte- nance facility designated by the supplier. Any repairs or alterations made by the user to this equipment, or equipment malfunctions, may give the telecommunications company cause to request the user to disconnect the equipment.

Users should ensure for their own protection that the electrical ground connections of the power utility, telephone lines, and internal metallic water pipe system, if present, are connected together. This precaution may be particularly important in rural areas.

CAUTION: Users should not attempt to make such connections themselves, but should contact the appropriate electric inspection authority, or electrician, as appro- priate.

32

Image 32
Contents 56K External Call Waiting Modem Table of Contents Introduction Contacting Actiontec Customer SupportSafety Information Product RegistrationProduct Features Getting StartedUsing the Telephone Answering Machine Functions with Windows Before You BeginInstalling the Modem Installing the Interface CablesModem Controls and Indicators Modem Indicators and ControlsDevice Driver Installation and Configuration Configuring WindowsPage Page Configuring Windows 95B Page Page Configuring Windows Page Page Configuring Windows NT Page Finish Page Installing Communications Software Modem’s Voice FeaturesPage To Ignore an Incoming Call Call Waiting FeatureTo Receive an Incoming Call while Online Using The Call Waiting Control Utility Basic AT Commands AT Command SetCommand Format Dial command AT Commands Affecting ITU-T V.90 OperationS38 56K Dial Line Rate default ExamplesHelp and Service Information Reconfiguring a Windows Dial-Up Networking Connection Declaration of Conformity Telecommunications Regulations
Related manuals
Manual 33 pages 59.15 Kb