Airlink101 AR550W3G Miscellaneous, Administrator Time-out, Remote Administrator Host Port

Page 52

3.2.2.4 Miscellaneous

Parameters

Description

 

 

Administrator Time-out

The system will log out the administrator after no activity for a

 

period of time. You may set the time-out period to zero to disable

 

this feature.

Remote Administrator Host: Port

This feature enables you to perform administration task from

 

remote host. If this feature is enabled, only the specified IP

 

address can perform remote administration. Setting the specified

 

IP address as 0.0.0.0 indicates any host can connect with this

 

product to perform administration task. You can use subnet mask

 

bits "/nn" notation to specified a group of trusted IP addresses, for

 

example, "10.1.2.0/24".

 

NOTE: When Remote Administration is enabled, port 80 will be

 

opened; you can change to other port number such as 8080.

Discard PING from WAN side

Check this box to enable Discard PING from WAN side. When

 

you enable this feature, your router will not respond to a “ping”

 

request from any host on the WAN side.

DoS Attack Detection

Check this box to enable the DoS Attack Detection. Router will

 

block the DoS once it is detected. Denial of Service (DoS) is a

 

common attack measure, by transmitting a great amount of data

 

or request to your Internet IP address and server, the Internet

 

connection will become very slow, and server may stop

 

responding because it is not capable to handle too much traffics.

 

 

Click on Save after you finished all settings.

48

Image 52
Contents Wireless N 150 3G/3.75G Travel Router Copyright Table of Contents Wireless Modem Status Wireless Status Statistics Information Introduction and safety information Product InformationSafety Information Package Contents System RequirementsHardware Configuration Hardware OverviewHood Assembly LED Indicators Configure the Router Use Power AdapterUse USB Cable View Available Wireless Windows 7 / Vista UsersPage Select language then click Next to continue Click on Wizard Page Page Page Page Click Finish Using Web Configuration Utility Page Wizard Page Page Page Click Finish Advanced Settings Basic SettingsNetwork Setup LAN SetupInternet Setup LAN IP AddressDial-Up Profile CountryTelecom 3G NetworkPassword AuthenticationAccount Primary DNSMaximum Idle Time NAT Disable Service NameAssign IP Address Page Page Dhcp Server Fixed Mapping Enable Previous / NextWireless Transmit PowerNetwork ID Ssid ChannelWireless Mode WPS SetupWireless Client List EncryptionConfiguring WPA-PSK / WPA2-PSK Encryption Configuring WEP EncryptionEncryption WPS Setup Page Config Status Config ModeConfig Method Wireless Client List WPS StatusChange Password Old PasswordNew Password ReconfirmSecurity Settings Packet FilteringOutbound Packet Filter Allow / Deny all to pass exceptThose match the following rules Source IPPort MAC LevelURL Blocking URL BlockingMAC Control MAC Access ControlAssociation Control Or denies wireless association from clients whose MAC Administrator Time-out Remote Administrator Host PortMiscellaneous Discard Ping from WAN sideAdvanced Setting System Log Click on Save after you finished all settings System Time Toolbox System Info Firmware Upgrade Backup Setting Reset to DefaultReboot UPnP Setting Domain Name or IP Address for Ping TestStatus System Status Wireless Status Troubleshooting Router again if you use 3G service to access Internet Appendix a Hardware Specification Technical Support