3. Hardware Installation
Front Panel
The front panel provides the following status LED’s.
LED | STATUS | Description | |
PWR/STAT | Off | No power | |
| Red On | 1. Power on | |
| Red Blink | 1. System startup | |
LAN | Off | no Ethernet link detected | |
| Green On | 10/100Mbps Fast Ethernet link detected. No activity. | |
| Green | Indicates traffic on the 10/100 Mbps LAN interface | |
| Blink | ||
|
| ||
WAN | Orange | Indicates traffic on the 10 Mbps WAN interface | |
Blink | |||
|
| ||
G | Yellow | Indicates the device is linking to another wireless device, | |
Blink | or active data is being transmitted via the wireless link. | ||
|
Rear Panel
The rear panel features 4 LAN ports, 1 WAN port and a Reset button. Refer to the following table for the meaning of each feature.
| Used to connect to the power outlet. Only use the power | |
Power (DC 5v) | adapter provided with the device. Use of an unauthorized | |
power adapter may cause damage to your device and | ||
| violate your warranty agreement. | |
Reset | Press the Reset Button for approximately ten seconds, to | |
reset all settings to factory default values. | ||
| ||
LAN | The | |
switch or Ethernet network. | ||
| ||
WAN | The | |
your AP Router to your xDSL or Cable modem. | ||
|
AP Router Default Settings
The default settings are shown in the following table.
User |
| |
Password | Admin | |
AP Router IP | 192.168.1.1 | |
Address | ||
| ||
AP Router Subnet | 255.255.255.0 | |
Mask | ||
| ||
RF ESSID | ||
11g RF Channel | 6 | |
Mode | Mixed (11b and 11g) | |
Encryption | Disabled | |
DHCP client | Enabled |
Alloy Wireless 802.11g User’s Guide | www.alloy.com.au | 4 |