Using Signal Stalker
To turn on Signal Stalker, turn SQUELCH fully
clockwise, then press FUNC + 
once except in WX search, band select, or program mode.
appears. Every 2 seconds, the scanner searches for frequencies in the range you specified in “Setting the Signal Stalker Options” on Page 32.
Note: To continue scanning normally while Signal Stalker is working, simply press SCAN.
When the scanner finds a frequency, it sounds the alert you specified in “Setting the Signal Stalker Options” on Page 32, and Found flashes. Press any key to confirm the displayed frequency. Press SCAN
to resume scanning. Or press 
or 
while the
frequency and 
appear to select the band where you are searching.
To turn on Signal Stalker and turn off normal
scanning, press FUNC + | twice. | and - - - - - - |
flash. |
|
|
To turn off Signal Stalker and turn on normal
scanning, press FUNC + 
three times. 
disappears.
35 | Beyond the Basics |