Resetting the Scanner
If the scanner’s display locks up or stops operating properly, you might need to reset the scanner.
Caution: This procedure clears all the information you have stored in the scanner. Before you reset the scanner, try turning it off and on to see if it begins working properly. Reset the scanner only when you are sure it is not working properly.
Make sure your scanner is turned off.
While holding down 2, 9, and HOLD, turn on the scanner. After about 3 seconds, the scanner initializes and CLEAr appears.
Follow these steps to restore the 150 preprogrammed frequencies stored in the scanner.
Make sure your scanner is turned off.
While holding down 3 and E, turn on the scanner. After several seconds, the scanner restores the frequencies and
Beyond the Basics | 54 |