Radio Shack 20-521 owner manual Plug the adapter’s barrel plug into your scanner’s

Page 14

1.Turn VOLUME/OFF counterclockwise until it clicks to make sure the power is turned off.

2.Set the adapter’s voltage switch to 9V.

3.Connect the 3.4 mm outer diameter/1.3 mm inner diameter tip to the adapter cord, matching TIP to –.

4.Plug the adapter’s barrel plug into your scanner’s

POWER jack.

5.Plug the other end of the adapter into your vehi- cle’s cigarette-lighter socket.

If you have installed rechargeable batteries and

set ALKALINE JACK NI-CD to NI-CD, the adapter powers the scanner and recharges the batteries at the same time.

Note: If the scanner does not operate properly when you use a DC adapter, unplug the adapter from the cig- arette-lighter socket and clean the socket to remove ashes and debris.

14

Image 14

Contents PRO-91 150-Channel Handheld Trunking Scanner Features Page Frequency Step Transmission Range MHz KHz FCC Notice Scanning LegallyContents General Guide to Scanning Special FeaturesTrunk Tracking Page Preparation Power SourcesUsing Internal Batteries Page Charging Nickel-Cadmium Batteries Using AC Power Using Vehicle Battery Power Plug the adapter’s barrel plug into your scanner’s Connecting the Antenna Connecting an Optional AntennaListening Safely Connecting AN EARPHONE/ HeadphonesTraffic Safety Connecting AN Extension Speaker Attaching the Belt ClipAbout Your Scanner Look AT the Keypad Look AT the Display Page Channel Storage Banks Service BanksUnderstanding Banks Monitor Memories Turning on the Scanner and Setting Squelch OperationStoring Known Frequencies Into Channels Searching for and Temporarily Storing Active Frequencies Limit SearchDirect Search Service Bank Search Search Skip Memory Listening to the Monitor Memories Moving a Frequency from a Monitor Memory to a ChannelScanning the Stored Channels Manually Selecting a ChannelPage Turning CHANNEL-STORAGE Banks on and OFF Special FeaturesDelay Locking OUT Channels PriorityPage Changing Search Speeds Using the KeylockUsing the Display Backlight Normal Search HypersearchTurning the Battery Save Function OFF/ON Turning the KEY Tone OFF/ONSkipping Data Signals Trunk Tracking Types of Trunking SystemsSetting the Scanner to the Trunk Tracking Mode Setting Squelch for the Trunk Tracking Mode Storing Trunked FrequenciesPage Scanning a Trunked Bank Monitoring an Active ID Temporarily Storing an ID into the Monitor ID MemoryUnlocking All IDs Locking Out IDsUnlocking a Single ID Using Trunk Tracking Scan Delay Monitoring IDsChannel Activity Bars Scan Lists Manually Storing IDs into Scan ListsMoving IDs to Scan Lists Deleting a Stored IDScanning the Scan Lists Scanning Type I and Hybrid Trunked SystemsProgramming a Fleet Map Size Fleets Subfleets IDs Blocks Used E1P1 E1P2 E1P3 Size E1P4 E1P5 E1P6 Size Selecting a Preset Fleet Map Programming a Hybrid System National Weather Frequencies General Guide to ScanningGuide to Frequencies Canadian Weather FrequenciesPrimary Usage Guide to the Action BandsTypical Band Usage VHF BandBand Allocation AbbreviationsVery High Frequency VHF Ultra High Frequency UHF Frequency Conversion Troubleshooting Problem Possible Remedy CauseError Adjust squelch for Resetting the Scanner Care and Maintenance Specifications Power Requirement AA Alkaline Batteries 6.0 VDC Page Page Limited One-Year Warranty RadioShack Division of Tandy Corporation Fort Worth, Texas