Toshiba TECRA M5 user manual LAN cable types, Connecting LAN cable

Page 118

Operating Basics

LAN

The computer has built-in support for Ethernet LAN (10 megabits per second, 10BASE-T), Fast Ethernet LAN (100 megabits per second, 100BASE-TX) and Gigabit Ethernet LAN (1000 megabits per second, 1000BASE-T).

This section describes how to connect/disconnect to a LAN.

Do not install or remove an optional memory module while Wake-up on LAN is enabled.

The Wake-up on LAN function consumes power even when the system is off. Leave the AC adaptor connected while using this feature.

LAN cable types

The computer must be configured properly before connecting to a LAN. Logging onto a LAN using the computer’s default settings could cause a malfunction in LAN operation. Check with your LAN administrator regarding set-up procedures.

If you are using Gigabit Ethernet LAN (1000 megabits per second, 1000BASE-T), be sure to connect with a CAT5E cable or higher. You cannot use a CAT3 or CAT5 cable.

If you are using Fast Ethernet LAN (100 megabits per second, 100BASE- TX), be sure to connect with a CAT5 cable or higher. You cannot use a CAT3 cable.

If you are using Ethernet LAN (10 megabits per second, 10BASE-T), you can connect with a CAT3 or higher.

Connecting LAN cable

To connect the LAN cable, follow the steps below.

■Connect the AC adaptor before connecting the LAN cable. The AC adaptor must remain connected during LAN use. If you disconnect the AC Adaptor while the computer is accessing a LAN, the system may hang up.

■Do not connect any other cable to the LAN jack except the LAN cable. Otherwise, malfunctions or damage may occur.

■Do not connect any power supplying device to the LAN cable that is connected to the LAN jack. Otherwise, malfunctions or damage may occur.

1.Turn off the power to the computer and to all external devices connected to the computer.

4-36	User’s Manual

Image 118

Contents User’s Manual Portable Personal ComputerDisclaimer CopyrightTrademarks FCC conditions FCC informationFCC notice Declaration of Conformity Information ContactVcci Class B Information Modem warning notice EU Declaration of ConformityConformity Statement Region selection Japan regulationsNetwork Compatibility Statement RedialPursuant to FCC CFR 47, Part If problems arise Type of serviceTelephone company procedures DisconnectionInstructions for IC CS-03 certified equipment Modem warning notice for Australia AT&F AT&W AT%TE=0 ATZUser’s Manual General conditions Following information is only for EU-member statesDescription on Laser specification Table of Contents Getting Started Table of Contents Power conditions KeyboardHW Setup Troubleshooting Legal Footnotes Copy Protection*9 -3 Images*10 Manual contents PrefaceIcons ConventionsAbbreviations KeysDisplay Key operationMessages Preface Xxiv User’s Manual Stress injury Heat injury General PrecautionsPressure or impact damage PC card overheating Mobile phoneIntroduction Equipment checklistHardware Documentation FeaturesSoftware Microsoft Windows XP ProfessionalMemory ProcessorLegal Footnote CPU*1 Legal Footnote General Main Memory*2Disks PowerLegal Footnote Battery Life*3 Legal Footnote HDD Drive Capacity*4Optical disk drive CD-ROM driveDVD-R DVD-RW DVD-RAM DVD-R DL DVD+R DVD+RW DVD+R DL Legal Footnote Graphics Processor Unit GPU*6 DisplayLegal Footnote LCD*5 KeyboardSlots PortsMultimedia Communications BluetoothModem Legal Footnote Wireless LAN*7 Wireless LANSecurity Special features Panel power on/off Intelligent powerBattery save mode Low batteryUtilities Fn-esse Bluetooth Stack forToshiba Wireless Toshiba , point to Utilities and click Fn-esseDiagnostic Tool Memory Boot UtilityPoint to Utilities and click SD Memory Boot Toshiba ConfigFreeAccessibility SettingsToshiba Password Toshiba Dual Pointing Device utilityOptions Slim Select Bay options Introduction User’s Manual System indicators Legal Footnote Non-applicable Icons*8Display latch MicrophoneExpressCard slot Cooling vents Cooling vents help CPU keep from overheatingPort ExpressCard ejectSD card slot USB 2.0 ports Ports complies with the USB 2.0 standardRight side Serial portDC in 15V jack Modem jackLAN jack Link indicatorLAN active indicator GreenNotches Battery lockBattery release latch Docking portScrew Hard disk drive HDD pack coverCover Display screen Display hingeFingerprint Sensor Stereo speakersLCD Sensor switch Power buttonTouch Pad Power System indicatorsBattery Keyboard indicators Caps LockUSB floppy disk drive Arrow modeNumeric mode Floppy disk slotWritable discs Optical disk drivesRegion codes for DVD drives and media CDsCD read DVDsFormats DVD read Speed maximum CD readDVD-ROM&CD-R/RW drive DVD read Speed maximum CD read CD-R write CD-RW writeAC adaptor 11 The AC adaptor 2-pin plugGrand Tour Grand Tour User’s Manual Setting up your work space Getting StartedGetting Started Placement of the computer Seating and posture Posture and positioning of the computerLighting Work habitsStrategic Rest Breaks Connecting the AC adaptorOther Things to Note Connect the power cord to the AC adaptor Connecting the power cord to the AC adaptor 3-pin plug Opening the displayTurning on the power Opening the LCD display panelStandby Mode Turning off the powerShut Down mode Boot mode Starting up for the first timeExecuting standby Benefits of standbyClick start, click Turn Off Computer and click Stand By Hibernation Mode Standby limitationsStarting Hibernation Mode Benefits of Hibernation ModeAutomatic Hibernation Data save in Hibernation Mode Create Optical Recovery DiscsRestarting the computer Restoring the preinstalled software from the Recovery HDD Menu appears, follow the on-screen instructions Operating Basics Using the Touch PadToshiba Dual Pointing Device Replacing the cap Using the AccuPointAccuPoint precautions Double-click Tap twiceUsing the Fingerprint Sensor How to Delete the Fingerprint Data Points to note about the Fingerprint Utility Fingerprint Registration Set Up ProcedureWindow Logon via Fingerprint Authentication Hints for Fingerprint Enrollment screen is displayedFingerprint Authentication Procedure GeneralFingerprint Single Sign-on Feature How to Swipe the Finger Fingerprint utility limitationsConnecting USB floppy disk drive Using the USB floppy disk driveDisconnecting USB floppy disk drive Changing Slim Select Bay modules Removing a moduleUsing optical disk drives Loading discs Pressing the eject buttonLay the CD/DVD, label side up, in the disc tray Removing discs Closing the CD/DVD disc trayHow to remove CD/DVD when the disc tray will not open Writing CDs on DVD-ROM&CD-R/RW driveMulti-Speed and High-Speed CD-RW Before writing or rewritingUltra-Speed CD-RW When writing or rewriting Writing CD/DVDs on DVD Super Multi driveLegal Footnotes Important messageCD-RW Multi-Speed and High-Speed DVD Specifications for Recordable Disc for General Version CD-RW Ultra-SpeedOperating Basics RecordNow! Basic for Toshiba Data Verification When using WinDVD Creator Platinum DLA for ToshibaHow to learn more about InterVideo WinDVD Creator How to make a DVD-VideoImportant information for use Operating Basics CD/DVDs Media careFloppy disks Sound system Volume ControlVolume control Microphone levelToshiba Mic Effect Audio power managementModem Graphic equalizerSetting Properties menuModem Selection ConnectingDialing Properties Wireless communications DisconnectingWireless LAN SecurityWorldwide operation Bluetooth wireless technologyBluetoothTM Stack for Windows by Toshiba Radio linksWireless communication Indicator Wireless communication switchIndicator status Indication Connecting LAN cable LAN cable typesCleaning the computer Disconnecting LAN cableUsing the Hard Disk Drive HDD Protection Moving the computerHDD Protection is disabled Taskbar IconHDD Protection Toshiba HDD Protection PropertiesDetection Level Detection Level Amplification DetailsHDD Protection Message Heat dispersal Keyboard Typewriter keysSoft keys Fn key combinations Function keys F1 … F12Emulating keys on enhanced keyboard Hot keys Keyboard Keyboard Fn Sticky key Keypad overlay Arrow modeWindows special keys Turning on the overlaysTemporarily using overlay overlay off Temporarily using normal keyboard overlay onNumeric mode Generating Ascii characters Temporarily changing modesKeyboard User’s Manual Power on Power off No operation Power and Power-Up ModesPower conditions ConnectedLED 2nd Battery off DC in green LED 2nd Battery DC in greenLED 2nd Battery off NotPower on Power off Power indicatorsLED 2nd Battery Power indicator Battery indicatorDC in indicator Flashing orangeBattery types Battery pack2nd battery pack option High capacity battery pack option Care and use of the battery packReal Time Clock RTC battery Safety precautions Power and Power-Up Modes Charging the batteries Battery charging notice ProceduresTime Monitoring battery capacity Maximizing battery operating timeRetaining data with power off Retention timeReplacing the battery pack Extending battery lifeReleasing the battery pack User Password field Toshiba Password UtilityUser Password Start All Programs Toshiba Utilities -Password UtilityOwner String text box User Token field Supervisor PasswordDisable button Start All Programs Toshiba Utilities SD Memory Card FormatPower-up modes Starting the computer by passwordWindows utilities Panel power on/offSystem Auto Off Hot keysAccessing HW Setup HW SetupHW Setup window Setup Boot Priority Boot Priority OptionsBar will appear only under the selected device HDD Priority Options No Fn key equivalent Default External Keyboard Fn keyCPU Device Config Parallel/PrinterStarting and Ending the Bios Setup Program Configuring the Execute-Disable Bit CapabilityStarting the Bios Setup Program Ending the Bios Setup Program Execute-Disable Bit CapabilityEnding the Bios Setup Program Halfway Diagnostic test is enabled Diagnostic ModeDiagnostic test is disabled Security controllerHW Setup User’s Manual Cards/memory Power devicesOptional Devices Peripheral devicesPC card Inserting a PC cardRemoving a PC card ExpressCardInserting an ExpressCard Removing an ExpressCard Inserting the ExpressCardFormatting an SD memory card SD cardInserting an SD card Removing an SD card Removing an SD cardMemory expansion Creation of a boot diskSD card care Installing memory module Removing the memory module cover Removing memory module Be sure that the cover is closed firmlyBattery pack Grasp the module by the sides and pull it outHard disk drive pack Battery chargerRemoving the hard disk drive pack Installing the hard disk drive pack 12 Removing the hard disk drive packSlim Select Bay HDD adaptor 14 Opening the lidExternal monitor 16 Closing the lid18 Connecting the S-Video cable to the Video-out jack Open the Control Panel and click Appearance and Themes Changing the resolutionDisplaying movies on a TV or CRT Select the Quadro NVS 110M tabPrecautions Link IEEE139419 Connecting the i.LINK IEEE1394 cable into the computer Point to i.LINK IEEE1394 device and clickAdvanced Port Replicator III Plus Serial port Security lockOptional Devices User’s Manual Troubleshooting Problem solving processPreliminary checklist Analyzing the problemHardware and system checklist System start-upProblem Procedure PowerOverheating power down Self testBattery AC powerProblemProcedure Minutes. If the Battery indicator glows after Keyboard PasswordProblem Real Time ClockInternal LCD display panel Hard disk driveCD-ROM DVD-ROM, DVD-Video DVD-ROM&CD-R/RW drive DVD Super Multi drive USB floppy disk drive SD cardDual Pointing Device PC cardExpressCard Touch Pad/AccuPointMouse icon USB mousePrinters and Other Hardware and select Click the Pointer Options tabFingerprint Sensor USB deviceMemory expansion Sound systemExternal monitor Link IEEE1394 deviceModem CarrierBluetooth LANTV output signal PrinterDisposing of PC and PC batteries Toshiba supportBefore you call Canada France Where to writeOutside of Europe Australia Germany & Austria China NetherlandsOutside of Europe United States of America United Kingdom Rest of EuropeLegal Footnotes CPU*1General Main Memory*2 Battery Life*3HDD Drive Capacity*4 Non-applicable Icons*8 Wireless LAN*7Graphics Processor Unit GPU*6 Copy Protection*910-4 Physical Dimensions SpecificationsEnvironmental Requirements Power Requirements Built-in ModemTransmitting level Impedance Error correctingPower supply Receiving levelSpecifications User’s Manual Display controller Display Controller and ModesVideo modes Frequency Video mode Type Resolution Character Colors ScanningVideo modes VGA PelsVideo Type Resolution Character Colors Scanning Mode Vertical Video modes XGA modelColors Frequency Hz Vertical 16M/16M Video modes SXGA+ model 64K/64K 100 640 16M/16M PowerMizer Figure B-1 Multiple Monitors and Quadro NVS 110MAnswer command AT CommandsRepeat last command +++ Escape sequenceEn Echo command Bn Communication standard settingDn Dial Hook control Ln Monitor speaker volumeMn Monitor speaker mode Request ID informationSelect pulse dialing Return on-line to data modeNn Modulation handshake Result code controlVn DCE response format Command Dial tone Busy Supported Result Code Detect SignalSelect tone dialing Result code selection, call progress monitoringZn Recall stored profile Dial tone detectBusy tone detect Cn Data Carrier Detect DCD controlKn Local flow control selection Load factory settingsGn V.22bis guard tone control Pn Select Pulse Dial Make/Break Ratio WWStore current configuration Tn Self-test commandsDisplay Current Configuration \Nn Error control mode selectionView numbers in blacklist \Qn Local flow control selection\Vn Protocol result code Cn Data compression controlResult Codes OK n=0,3 Error Otherwise S0 Auto answer ring number RegistersRegister values ATSn?S2 AT escape character user defined S3 Command line termination character user definedS1 Ring counter S4 Response formatting character user definedS6 Wait before dialing S5 Command line editing character user definedS7 Connection completion time-out S11 Dtmf dialing speed S8 Comma pause timeS12 Escape guard time S37 Dial line rate AT command set result codes Result Code Numeric DescriptionDELAYED*2 Registers User’s Manual Mode Function Transmission speedTable E-1 Result codes for a V.90 connection Connect 54666 ECAT Command User’s Manual Card Specifications Wireless LANRadio Characteristics Modulation Wireless Ieee 802.11 Channels Sets Revision B and GSupported Frequency Sub-bands Technique102457*1 Wireless Ieee 802.11 Channels Sets Revision a122467*2 132472*2 5540 Bluetooth wireless technology Interoperability Appendix GBluetooth wireless technology Interoperability General Bluetooth wireless technology and your HealthRegulatory statements European Union EU and EftaUSA-Federal Communications Commission FCC Using BluetoothTM Card from Toshiba equipment in Japan TaiwanBluetooth wireless technology Interoperability Device Authorization Japan Approvals Institute for Telecommunications EquipmentBluetooth wireless technology Interoperability User’s Manual Certification agencies AC Power Cord and ConnectorsEurope Switzerland GermanyToshiba Anti-theft Protection Timer AppendixToshiba Anti-theft Protection Timer User’s Manual Glossary AbbreviationsGlossary Ascii Glossary-4 User’s Manual Glossary-5 Erase See delete Glossary-7 Glossary-8 User’s Manual Level 2 cache See cache Main board See motherboardGlossary-10 User’s Manual Glossary-11 Glossary-12 User’s Manual Glossary-13 Glossary Glossary-14 User’s Manual Index Index Index-3 Index-4 User’s Manual Index-5 Index Index-6 User’s Manual

Related manuals

Manual 2 pages 7.53 Kb