N[LIGHT SENSOR] SWITCH
When AC adapter is connected, position the light sensor switch to:
*“AUTO” to activate an auto backlight.
*“ON” to set continuous LCD backlight.
*“OFF” to deactivate LCD backlight.
The
REMOTE SENSOR
FEATURES
•Remote temperature transmission to the main unit via 433 MHz signal
•Case can be wall mounted using
•100 feet transmission range without interference
•LCD display of measured temperature
•Temperature display unit (C°or F°) selection
•Transmission channel selection
E
ALED INDICATOR
Flashes once when the remote sensor transmits a reading to the main unit.
Flashes twice when battery power is low.
BBATTERY COMPARTMENT Holds two AA batteries.
CRESET
Resets all previous settings.
DCHANNEL SELECTOR
Selects the desired channel before installing batteries.
E
F°C/ °F SWITCH
Selects the temperature display in Fahrenheit or Celsius.
BEFORE YOU BEGIN
1. | We recommend using alkaline batteries for the main unit |
2. | and remote sensor. |
Avoid using rechargeable batteries. |
1
2
3
THERMO – SENSOR
A | MADE IN CHINA | F |
C |
| |
| D | |
|
| B |
3. | Insert batteries before first use, matching the polarity as |
4. | shown in the battery compartment. |
Always install batteries in the remote sensor before the | |
5. | main unit. |
Press RESET after each battery change, using paper clip or | |
6. | similar tool. |
During an initial setup, place the main unit as close as | |
7. | possible to the remote sensor. |
After reception is established (remote temperature will | |
| appear on the receiver’s display), position the remote sensor |
| and main unit within the effective transmission range of |
| 100 feet. |
NOTE:
5
1.Avoid setting the time and date on the main unit before the outdoor temperature is displayed.
2.The effective operating range may be influenced by the surrounding building materials and how the receiver and transmitter are positioned. 6