Setting the Alarm, Snooze, HOW to Stop AN Alarm

“W” (Weekday alarm), “ S” (Single day alarm), and “Pre-AL” (Pre-alarm) icons will indicate which alarm mode is armed. You can enable or disable an alarm by pressing the [ + ],[ – ] buttons in alarm display mode. Press MODE to toggle between alarm modes or to return to the default display.

SETTING THE ALARM

To set any alarm,

1. Press [ALARM ON/OFF] once to display a specific alarm time. If the selected alarm is off, “OFF” will be displayed.

2. Press and hold [ALARM ON/OFF] for 2 seconds. The hour digit will flash.

3. Enter the hour using [ - ] or [ + ] buttons.

4. Press [ALARM ON/OFF] again. The minute digits will flash.

5. Enter the minutes using [ - ] or [ + ] buttons.

6. Press [ALARM ON/OFF] again to exit from the alarm time mode.

7. Repeat the same procedure to set any of alarms (weekly, daily or pre-alarm).

SNOOZE

When the alarm sounds, press the LIGHT/ SNOOZE button to temporarily stop the alarm. After depressing, the alarm sound will resume in 5 minutes.

If the alarm is not disabled after that, it will sound for 4 more minutes and then will stop by itself.

HOW TO STOP AN ALARM

Press [ALARM ON/OFF ] on the main unit to disable any alarm.

PRECAUTIONS

This product is engineered to give you years of satisfactory service if handled carefully. Here are a few precautions:

1.Do not immerse the units in water.

2.Do not clean the units with abrasive or corrosive materials. They may scratch the plastic parts and corrode the electronic circuits.

3.Do not subject the product to excessive force, shock, dust, temperature, or humidity, which may result in malfunctions, shorter lifespan, damaged batteries, and damaged parts.

4.Do not tamper with the units' internal components. Doing so will invalidate the warranty and may cause damage. These units contain no user-serviceable parts.

5.Use only fresh batteries. Do not mix new and old batteries.

6.Read the user's manual thoroughly before operating the units.