The jumper settings are schematically depicted in this manual as follows:
A pair of needle-nose pliers may be helpful when working with jumpers. If you have any doubts about the best hardware configuration for your application, contact your local distributor or sales representative before you make any changes. Generally, you simply need a standard cable to make most connections.
2.4.1Clear CMOS (JP1)
The PCM-3362 single board computer contains a jumper that can erase CMOS data and reset the system BIOS information. Normally this jumper should be set with pins 1-2 closed. If you want to reset the CMOS data, set CMOS1 to 2-3 closed for just a few seconds, and then move the jumper back to 1-2 closed. This procedure will reset the CMOS to its default setting.
Warning! To avoid damaging the computer, always turn off the power supply before clearing CMOS.
Table 2.3: Clear CMOS (JP1)
Setting | Function |
1-2 | Normal (default) |
2-3 | Clear CMOS |
2.4.2LVDS Panel Power Select (JP2)
Table 2.4: LVDS Panel Power Select (JP2)
Setting | Function |
1-2 | 5 V |
2-3 | 3.3 V (default) |
