AMD TPC-660G manual Specifications, Safety, Environment Operating Temperature 0 ~ 50 C 32 ~ 122 F

Page 13

1.2 Specifications

1.2.1 System Kernel

CPU: GeodeLink Control Processor LX800 500MHz

BIOS: Award 512KB flash memory

South Bridge: GeodeLink Control Processor CS5536

VGA: GeodeLink Control Processor LX800 500MHz

Ethernet: Realtek RTL8100BL; IEEE 802.3u protocol compatible

Watchdog Timer: W83627 watchdog timer; 1.6 second timeout period

IDE: 1 EIDE channel supports one CompactFlash socket onboard (Master) and one IDE interface harddrive (Slave)

1.2.2 I/O Ports

2 serial ports: RS-232 (COM1) and RS-232/422/485 (COM2)

1 RJ-45 Ethernet port

1 PS/2 port: 6-pin mini-DIN ports for keyboard and mouse

2 USB 2.0 Ports: compliant with USB 1.0 and 1.1.

PC-104 slot: supportS 8-bit I/O card only.

Note:

COM1 and COM2 only support half-duplex

 

(Maximum baud rate: 115.2Kbps)

1.2.3 Safety and Environment

Safety

FCC Class A

CE certificated

The front bezel is compliant with NEMA 4 and IP65

Environment

Operating Temperature: 0 ~ 50° C (32 ~ 122° F)

Storage Temperature: -20 ~ 60° C (-4 ~ 140° F)

Humidity: 40° C @ 10~95% relative humidity (non-condensing)

Vibration: 1 grms (5~500Hz)

3

Chapter1

Image 13
Contents TPC-660G This Manual Covers the Following Models Copyright AcknowledgementsProduct Warranty 1 year FCC Class a Technical Support and Assistance Packing List Safety InstructionsPage Contents Chapter Features in Windows XP Embedded Appendix F Fuse Specifications Page General Information Introduction Powerful Communication CapabilityFanless Bright DisplaySafety SpecificationsEnvironment Operating Temperature 0 ~ 50 C 32 ~ 122 F Touchscreen Specifications LCD SpecificationsPower Backlight 1 Ccfl Backlight Life Time 20,000 hoursPanel Mounting I/O Ports ArrangementPanel Mounting Exploded DiagramDimensions & Cutout Dimensions and CutoutPage System Setup Unpack the Package Power Connector and Power Lines Plugging in the Power Line Bootup Screen Page System Engine Mainboard Connectors & Jumper Settings Main Board Connectors Page Software Configuration Device Manager VGA Driver InstallationUpdate Driver Update Wizard-2 Update Wizard-4 Update Wizard-6 10 Device Manager Entertainment Encryption/Decryption Driver12 Install Wizard 14 Driver Installation Complete Page Features Windows XP Embedded EWF Features in Windows XP EmbeddedAdvantech Utilities HormVersion Information Serial Port Settings Jumper Setting Appendix a Serial Port SettingsData Format Control Setting SW2 Baud Rate Setting SW3 Watchdog Timer Programming Overview Appendix B Watchdog Timer ProgrammingFigure B.1 Watchdog Timer Programming Watchdog Timer ProgrammingTable B.1 Watchdog Timer Registers Example Programs Enable watchdog timer and set 10 sec. as timeout intervalEnable watchdog timer and set 5 minutes as timeout interval Enable watchdog timer to be reset by mouse Enable watchdog timer to be reset by keyboard Generate a time-out signal without timer counting Page Watchdog Timer Programming on WinCE DeviceIOControl Appendix C Watchdog Timer Program- ming on WinCELpvoid lpOutBuffer Parameters Ioctl Wdtenable How to Use the Control CodeIoctlwdtgettimeout Examples CTLCODEFILEDEVICEUNKNOWN,ID, METHODBUFFERED, FileanyaccessAppendixC Page Accessory Kit Assembly Procedure CompactFlash to IDE Transfer Kit Appendix D Accessory Kit Assembly ProcedureFigure D.3 CompactFlash Slot Figure D.6 Connect the CD-ROM via the IDE Cable Touchscreen Installation Configuration Driver Installation Appendix E Touchscreen Installation & ConfigurationFigure E.3 Install Wizard Figure E.5 Uninstall Uninstall the DriverCalibrate Touchscreen CalibrationFigure E.8 Standard Calibration Figure E.10 Advanced Calibration Figure E.11 Advanced Calibration Figure E.13 Draw DrawOption Figure E.14 Clear ScreenFuse Specifications Fuse Specifications Appendix F Fuse SpecificationsFuse Replacement