Acer 500L Num Lock After Boot, Memory Test, Configuration Table, Boot from LANDesk Service Agent

Page 71

Num Lock After Boot

This parameter allows you to activate the Num Lock function upon booting. The default setting is Enabled.

Memory Test

When set to Enabled, this parameter allows the system to perform a RAM test during the POST routine. When set to Disabled, the system detects only the memory size and bypasses the test routine. The default setting is Enabled.

Configuration Table

This parameter allows you to enable or disable the appearance of the configuration table after POST but before booting. The configuration table gives a summary of the hardware devices and settings that BIOS detected during POST.

Boot from LANDesk Service Agent

When set to Enabled, the system boots from a LANDesk Service Agent network instead of your desktop system. The LANDesk Service Agent is IEEE-standards-based code that intervenes in the boot process. Please refer to your LANDesk Manual for more information.

When set to Disabled, the system boots from the drive specified in the Boot Sequence parameter.

Chapter 3 BIOS Utility

3-25

Image 71
Contents AcerAltos 500L Copyright Important Safety Instructions Page Page FCC Class B Radio Frequency Interference Statement Getting Started Conventions Table of Contents Bios Utility Page Xii Standalone System System HousingFront Panel FeaturesRear Panel Internal Structure Opening the Housing Panels Left Panel Inch Floppy Drive Installing Disk DrivesInch Drives Hard Disk Drives Installing Expansion Cards System Housing Page System Board Major Components System Board Layout Jumper and Connector Locations Jumpers and ConnectorsConnector Functions Jumper SettingsPower switch ESD Precautions Attaching the Processor Fan Sink Installing the Pentium II ProcessorSystem Board AcerAltos 500L User’s Guide Installing a Pentium II Processor AcerAltos 500L User’s Guide Removing a Pentium II Processor AcerAltos 500L User’s Guide Memory Configurations Memory UpgradeInstalling a Dimm Removing a Dimm Reconfiguring the System System Error Messages Error MessagesSoftware Error Messages Mmmmssssooo Wxxxx System Board Correcting Error Conditions Bios Utility Setup Utility Entering SetupBios Utility System Information External Cache ProcessorProcessor Speed Internal Cache SizeIDE Secondary Channel Slave IDE Primary Channel MasterIDE Primary Channel Slave IDE Secondary Channel MasterPS/2 Mouse Serial PortParallel Port Main Board ID Product InformationProduct Name System S/NMain Board S/N System Bios VersionDMI Bios Version Floppy Drives Disk DrivesIDE Primary Channel Master LS-120 Drive Compatible AsIDE Drives IDE Secondary Channel Slave IDE Primary Channel SlaveIDE Secondary Channel Master Enhanced IDE Features Hard Disk Block Mode Bios Utility Base Address Onboard PeripheralsSerial Ports 1 3BCh 378h Operation ModeEPP Onboard Device SettingsUSB Host Controller Floppy Disk ControllerIDE Controller PS/2 Mouse ControllerSMBus Interrupt IRQ9 IDE Hard Disk Standby Timer Power ManagementPower Management Mode System Wake-up Event Power Switch 4 secSystem Sleep Timer Modem Ring IndicatorBoot Sequence Boot OptionsFirst Hard Disk Drive Fast BootSilent Boot Memory Test Num Lock After BootConfiguration Table Boot from LANDesk Service AgentDate Date and TimeTime System Security Setup PasswordTo set or change a Password Set or Change Password To remove your Setup Password To bypass Setup Password Power-on PasswordDisk Drive Control Power-on PasswordBios Utility Memory/Cache Options Advanced OptionsMemory at 15MB-16MB Reserved for Internal Cache CPU CacheExternal Cache PnP/PCI Options Memory Parity ModePCI IRQ Setting VGA Palette Snoop PCI IRQ SharingPlug and Play OS Reset Resource AssignmentsCPU Frequency Graphics Aperture SizeProcessor Speed Bus FrequencyCPU Multiple Load Default Settings Abort Settings Change Exit Setup SCSI/VGA Combo Card Page LCD Module Event Log List