Acer Z5750, Z3751, Z3750, Z5751 manual Post Code Checkpoints

Checkpoint Description

FFThe flash has been updated successfully. Make flash write disabled. Disable ATAPI hardware. Restore CPUID value back into register. Give control to F000 ROM at F000:FFF0h.

POST Code Checkpoints

The POST code checkpoints are the largest set of checkpoints during the BIOS preboot process. The following table describes the type of checkpoints that may occur during the POST portion of the BIOS.

Checkpoint	Description
03	Disable NMI, Parity, video for EGA, and DMA controllers. Initialize BIOS, POST, Runtime
	data area. Also initialize BIOS modules on POST entry and GPNV area. Initialized CMOS
	as mentioned in the Kernel Variable "wCMOSFlags."
04	Check CMOS diagnostic byte to determine if battery power is OK and CMOS checksum is
	OK. Verify CMOS checksum manually by reading storage area.
	If the CMOS checksum is bad, update CMOS with power-on default values and clear
	passwords. Initialize status register A.
	Initializes data variables that are based on CMOS setup questions.
	Initializes both the 8259 compatible PICs in the system
05	Initializes the interrupt controlling hardware (generally PIC) and interrupt vector table.
06	Do R/W test to CH-2 count reg. Initialize CH-0 as system timer.Install the POSTINT1Ch
	handler. Enable IRQ-0 in PIC for system timer interrupt. Traps INT1Ch vector to
	"POSTINT1ChHandlerBlock."
08	Initializes the CPU. The BAT test is being done on KBC. Program the keyboard controller
	command byte is being done after Auto detection of KB/MS using AMI KB-5.
0A	Initializes the 8042 compatible Key Board Controller.
0B	Detects the presence of PS/2 mouse.
0C	Detects the presence of Keyboard in KBC port.
0E	Testing and initialization of different Input Devices. Also, update the Kernel Variables.
	Traps the INT09h vector, so that the POST INT09h handler gets control for IRQ1.
	Uncompress all available language, BIOS logo, and Silent logo modules.
13	Early POST initialization of chipset registers.
24	Uncompress and initialize any platform specific BIOS modules. GPNV is initialized at this
	checkpoint.
30	Initialize System Management Interrupt.
2A	Initializes different devices through DIM.
	See DIM Code Checkpoints section for more information.
2C	Initializes different devices. Detects and initializes the video adapter installed in the
	system that have optional ROMs.
2E	Initializes all the output devices.
31	Allocate memory for ADM module and uncompress it. Give control to ADM module for
	initialization. Initialize language and font modules for ADM. Activate ADM module.
33	Initializes the silent boot module. Set the window for displaying text information.
37	Displaying sign-on message, CPU information, setup key message, and any OEM
	specific information.
38	Initializes different devices through DIM. See DIM Code Checkpoints section for more
	information. USB controllers are initialized at this point.
39	Initializes DMAC-1 & DMAC-2.
3A	Initialize RTC date/time.

70 Aspire Z3750 / Z3751 / Z5750 / Z5751 AIO Computer Service Guide