Error Message List
Error Messages | FRU/Action in Sequence |
|
|
Device Address Conflict | Run “Load Default Settings” in BIOS Setup Utility. |
| RTC battery |
| System board |
|
|
Allocation Error for device | Run “Load Default Settings” in BIOS Setup Utility. |
| RTC battery |
| System board |
|
|
Failing Bits: nnnn | DIMM |
| BIOS ROM |
| System board |
|
|
Fixed Disk n | None |
|
|
Invalid System Configuration Data | BIOS ROM |
| System board |
|
|
I/O device IRQ conflict | Run “Load Default Settings” in BIOS Setup Utility. |
| RTC battery |
| System board |
|
|
Operating system not found | Enter Setup and see if fixed disk and drive A: are properly identified. |
| Diskette drive |
| Hard disk drive |
| System board |
|
|
Error Message List
No beep Error Messages | FRU/Action in Sequence |
|
|
No beep, | Power source (battery pack and power adapter). See “Power |
blank. | System Check” on page 59. |
| Ensure every connector is connected tightly and correctly. |
| Reconnect the DIMM. |
| LED board. |
| System board. |
|
|
No beep, | Power source (battery pack and power adapter). See “Power |
blank. | System Check” on page 59. |
| Reconnect the LCD connector |
| Hard disk drive |
| LCD inverter ID |
| LCD cable |
| LCD Inverter |
| LCD |
| System board |
|
|
No beep, | Reconnect the LCD connectors. |
blank. But you can see POST on an external | LCD inverter ID |
CRT. | LCD cable |
| |
| LCD inverter |
| LCD |
| System board |
|
|
No beep, | Ensure every connector is connected tightly and correctly. |
blinking cursor shown on LCD during POST. | System board |
|
|
No beep during POST but system runs correctly. | Speaker |
| System board |
|
|
Chapter 4 | 63 |