Motorola APCO25, BC796D manual Applying Power for Vehicle Installation

Applying Power for Vehicle Installation

You can power your scanner using either the supplied DC power cord or your vehicle’s cigarette lighter socket using DC cigarette lighter power cord.

Caution: You must use a power source that supplies 13.8 V DC and delivers at least 700 mA. Your standard 12 V car battery should be sufficient. The cord connector’s center tip must be set to positive and its plug must fit the scanner’s DC 13.8 V jack. The supplied DC power cord meets these specifications. Using a power cord that does not meet these specifications could damage the scanner or the adapter.

•Always connect the adapter or DC power cord to the scanner before you connect it to the power source. When you finish, disconnect the adapter or DC power cord from the power source before you disconnect it from the scanner.

•For added safety and to protect your scanner, disconnect the cable from your vehicle battery’s

negative (-) terminal before you begin.

Follow these steps to connect the supplied DC power cord.

1.Connect the power cord’s black wire to a chassis ground, such

as a metal screw attached to a metal part of the vehicle’s frame. Be sure that the screw is not insulated from the frame by a plastic part.

2.Connect the power cord’s red wire (with in-line fuse) to a source

of voltage that turns on and off with the ignition switch, such as a spare accessory terminal in your vehicle’s fuse box.

3. Insert the power cord’s barrel plug into the DC 13.8 V jack on the back of the scanner.

4.Reconnect the cable to the vehicle battery’s negative (-) terminal.

To power the scanner from a vehicle’s 12 V power source (such as a cigarette-lighter socket), you need a cigarette-lighter adapter.

To connect an optional DC cigarette-lighter power cable, insert

its barrel plug into the DC 13.8 V jack on the back of the scanner, then plug the power cable into your vehicle’s cigarette lighter socket.

Note: If you use a cigarette-lighter power cable and your vehicle’s engine is running, you might hear electrical noise from the engine while scanning. This is normal.

16