Clevo D901C manual RAM Module Removal cont’d, Contact Warning

2.Disassembly

Disassembly

Figure 6

RAM Module

Removal (cont’d.)

e. Pull the	release
latch(es).
d. Remove	the mod-
ule(s).



Contact Warning

Be careful not to touch the metal pins on the module’s connecting edge. Even the cleanest hands have oils which can attract particles, and degrade the module’s performance.

6.	Gently pull the two release latches 16 & 17 on the sides of the memory socket in the direction indicated by the
	arrows (Figure e).
7.	The RAM module 18 will pop-up (Figure f), and you can then remove it.
.
	e.	f.

17

18

16

8.Pull the latches to release the second module if necessary.

9.Insert a new module holding it at about a 30° angle and fit the connectors firmly into the memory slot.

10.The module will only fit one way as defined by its pin alignment. Make sure the module is seated as far into the slot as it will go. DO NOT FORCE IT; it should fit without much pressure.

11.Press the module in and down towards the mainboard until the slot levers click into place to secure the module.

12.Replace the RAM fan, cover and screws.

13.Restart the computer to allow the BIOS to register the new memory configuration as it starts up.



18. RAM Module(s)

2 - 10 Removing the System Memory (RAM)