Yamaha manual Install the CD Writing Software, Set Up the CRW2200IX Drive

Page 21

Setup Procedures

Install the CD Writing Software

Before connecting the CRW2200IX drive and the computer as described below, make sure that you have installed appropriate CD writing software (→P. 5). If you use Windows and if the CD writing software is newly installed, first disconnect all IEEE1394 devices from your computer. After properly installing the software, you can connect the CRW2200IX drive. For information about how to install the software, refer to the documentation that came with it.

Set Up the CRW2200IX Drive

If your computer has no built-in IEEE1394 port, you will first need to install an IEEE1394 interface card (purchased separately). For information about how to install the card, refer to the documentation that came with it.

1Turn on the computer.

2Make sure that the power switch on the rear panel of the CRW2200IX drive is set to STANDBY.

3Connect the included AC adapter to the DC-IN connector of the drive with the arrow on the adapter plug facing left, as shown below.

DC-IN connector

Screw Arrow

13

Image 21

Contents Page FCC Information U.S.A Achtung English Safety Precautions Iii Precautions for Transportation About handling CD-R/RW discsCopyrights Table of Contents Introduction Features of the CRW2200IX DriveHigh-fidelity digital audio CD Text supportAbout IEEE1394 Yamaha Buffer Underrun Protection Buffer Underrun DefinedBefore Use System RequirementsWindows Users CD Writing Software Macintosh UsersHard Drive Space Operating SystemCD-R discs*1 Supported DiscsCD-RW discs*2 High Speed CD-RW discs*3About Partial CAV Constant Angular Velocity About CD-ROMsSerial No Serial NumberFront Panel Front and Rear of Unit➂ DC-IN connector ➁ Power switch STANDBY/ONRear Panel ➀ Line OUT jacks L/RWindows Users Setup ProceduresMacintosh Users ConnectingSet Up the CRW2200IX Drive Install the CD Writing SoftwareElectrical plugs/sockets vary according to country/region LED Turn on the CRW2200IX driveConnection to a PC notebook computer via CardBus card Connection to a PC desktop or tower type computerRear panel Connection to a Macintosh computerFor Windows 98 Second Edition/Me Configuring for the Operating SystemYou can also check the FireWire version in this window Connecting Devices Connecting and Disconnecting IEEE1394 DevicesDisconnecting Devices OperationEjecting a Disc Loading a DiscEjecting a Disc in an Emergency Yamaha CD-R/RW Drive web site TroubleshootingDrive does not turn on Computer does not start upDisc keeps being ejected Disc tray does not openDisc is not loaded Properties setting of the CRW2200IX drive Setting of the Windows Media PlayerNo sound of CD-DA audio CD disc is audible Other symptoms Buffer Underrun error message is displayedUnstable operations Connecting in a daisy-chain Connecting Multiple IEEE1394 Peripherals TogetherConnecting in a tree AppendixAppendix Writing Modes Disc-at-Once DAOTrack-at-Once TAO Packet Writing Session-at-Once SAOAbout the Firmware Determining the Firmware Version of the CRW2200IX driveFor Macintosh Status Indicator Messages LED Color LED Indicator MessagesSupported Formats CRW2200IX SpecificationsTwo 6-pin connectors power not supplied to connectors ports AC adapter CRW2200IX series complies with the following specificationsIndex SymbolsYamaha CD-R/RW Drive web site Russia EUROPE, Eastern Europe