Attaching Adapter Plate to Projector
Note: The projector you are installing may differ in appearance from the sample illustrated below.
Place projector upside down. Locate adapter plate (B) with notch facing forward as close to projector center of
5 gravity as possible without covering any mounting holes. Loosen channels with 4 mm security
Note: Some projectors have feet which can be removed and the corresponding threaded insert can be used for a mounting hole.
Note: Once channels are in position retighten fasteners.
*Notch indicates front of projector.
CHANNEL
FOOT OF CHANNEL
MOUNTING HOLE
B
*
GENERIC PROJECTOR
Attach adapter plate (B) to projector using one screw (G, H, I or J) for each channel as shown below. Tighten all
6 screws, while keeping the center of gravity. Be sure that adapter plate (B) is straight. Adjust the feet of the chan- nels to keep the adapter plate level. Tighten all screws with 4 mm security
Note: Projectors will require different size screws for mounting. Use a combination of screws (G, H, I or J) and
foot adjustment that will result in channels of adapter plate (B) fi tting tightly against projector. Important: In order to properly engage the threads in the mounting holes, the screw must be turned at least 3 full turns.
Note: If using screw (G), place washer (K) between screw (G) and foot of channel.
CAUTION
•It is the responsibility of the installer to ensure that the projector is properly ventilated. Feet of channels are used to raise the mount off the projector surface.
B
G, H, I or J
FOOT OF CHANNEL
8 of 12 | ISSUED: |
Visit the Peerless Web Site at www.peerlessmounts.com | For customer care call |