Peerless Industries PRS-UNV-W, PRS-UNV-S manual Projector Alignment

Projector Alignment

To adjust yaw (swivel) for threaded rod mounting applications: Loosen locknuts on threaded rods (refer to

9 step four), until projector mount can be rotated. Rotate mount to desired position and retighten screws or lock- nuts.

To adjust yaw (swivel) for extension column applications: Loosen screw on projector mount assembly (A) indicated below until projector mount can be rotated. Rotate mount to desired position and retighten screw.

To adjust pitch (forward and backward tilt): Using 4 mm security t-wrench (L) (security adjustment models) or a phillips screwdriver (non-security adjustment models), loosen two screws for pitch adjustment on projector mount assembly (A) indicated below. Tilt mount to desired position and retighten screws.

To adjust roll (side to side tilt): Using 4 mm security t-wrench (L) (security adjustment models) or a phillips screwdriver (non-security adjustment models), loosen two screws for roll adjustment on projector mount assembly (A) indicated below. Tilt mount to desired position and retighten screws.

A

SCREWS FOR PITCH

ADJUSTMENT

SCREW FOR SWIVEL STOP

SCREWS FOR ROLL

ADJUSTMENT

10 of 12	ISSUED: 09-19-05 SHEET #: 055-9441-10 06-04-11
Visit the Peerless Web Site at www.peerlessmounts.com	For customer care call 1-800-865-2112 or 708-865-8870.

© 2011, Peerless Industries, Inc. All rights reserved. All other brand and product names are trademarks or registered trademarks of their respective owners.