Peerless Industries PRG-1W, PRG-1S manual Tools Needed for Assembly, Table of Contents

Page 2

NOTE: Read entire instruction sheet before you start installation and assembly.

WARNING

Do not begin to install your Peerless product until you have read and understood the instructions and warnings contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, please call Peerless customer care at 1-800-865-2112.

This product should only be installed by someone of good mechanical aptitude, has experience with basic building construction, and fully understands these instructions.

Make sure that the supporting surface will safely support the combined load of the equipment and all attached hard- ware and components.

Never exceed the Maximum UL Load Capacity. See page 1.

If mounting to wood joist ceilings, make sure that mounting screws are anchored into the center of the joist. Use of an "edge to edge" stud fi nder is highly recommended.

Always use an assistant or mechanical lifting equipment to safely lift and position equipment.

Tighten screws fi rmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding power.

This product is intended for indoor use only. Use of this product outdoors could lead to product failure and personal injury.

This product was designed and intended to be mounted to the following supporting surfaces checked below with the hardware included in this product as specifi ed in the installation sheet. To mount this product to an alternative supporting surface, contact Peerless customer care at 1 800 865-2112.

This product was designed to be installed on the following ceiling construction only;

CEILING CONSTRUCTION

ADDITIONAL HARDWARE REQUIRED

x

Wood Stud

None

x

Wood Joist

None

x

Solid Concrete

None

 

Brick

Contact Customer Service (Not Evaluated by UL)

 

Other or unsure?

Contact Customer Service (Not Evaluated by UL)

Tools Needed for Assembly

stud fi nder ("edge to edge" stud fi nder is recommended)

phillips screwdriver

drill

5/16" bit for concrete surface

5/32" bit for wood studs

level

Table of Contents

 

Parts List

3

Installation to Extension Columns / Ceiling Plate

4

Installation to Wood Joist Ceilings

5

Installation to Concrete Ceilings

6

Installation to Threaded Rods

7

Attaching Adapter Plate to Projector

8

Attaching Adapter Plate to Projector Mount

9

Cable Management

10

Projector Alignment

11

Accessories

12, 13

2 of 13

ISSUED: 08-15-07 SHEET #: 055-9491-7 06-11-11

Visit the Peerless Web Site at www.peerlessmounts.com

For customer care call 1-800-865-2112 or 708-865-8870.

Image 2
Contents Features Models PRG-1, PRG-1S, PRG-1WTools Needed for Assembly Table of ContentsParts List Installation to Extension Column / Ceiling Plate Skip to stepInstallation To Wood Joist Ceilings Installation to Concrete Ceilings Illustration aInstallation to Threaded Rod Not evaluated by UL Professional installation onlyInstalling PAP-UNV Adapter Plate sold separately Attaching Adapter Plate to ProjectorAttaching Adapter Plate to Projector Mount Arrow Indicates Front of Mount Captive ScrewCables with Combination VGA Connector RCA Plugs Cable ManagementProjector Alignment PRG Series Projector Mount Accessories Cord Management