InFocus SP-CEIL-004 installation instructions Wall Mount Installation

FIGURE 3	Wall Mount Installation		FIGURE 4
	Complete the following steps to install the projector mount and projector
	to your wall. (FIGURE 4)
	Note: Look at the bottom of the swivel bracket (G) and locate the arrow.
	Make sure you install the projector mount with the arrow pointing toward
	your screen.
	15.	Use the Allen wrench to remove the upper plate (E) from the swivel
		bracket (G).
	16.	Use the Allen wrench to remove the two screws from the enclosed
		end of the of the suspension adapter ( N), and place it (N) into the
		slotted extension on the upper plate (E). Make sure that the two (2)
		outer holes on the suspension adapter (N) align with the holes on
		the slotted extension on the upper plate (E).
	17.	Screw the two screws removed in step 2 into the two (2) holes to
		secure the suspension adapter (N) to the upper plate (E).
	18.	Attach the swivel bracket (G) to the suspension adapter (N) and
		secure them with two screws removed in step 1.
	19.	Secure the upper plate (E) to the wall (M) using the commercially
		available hardware (F) suitable for your environment. Be sure that
		the swivel bracket (G) arrow is pointing toward your screen.
	20.	Carefully raise the projector (C) with the mounting bracket (B)
		attached and insert it into the bottom of the swivel bracket (G) by its
		tabs.
	21.	Rotate the projector (C) with the mounting bracket (B) attached
		180º so that the projector’s focus rings is pointing	toward your
		screen.
	22.	Align the safety screw (H) on the swivel bracket (G) with the end of
		the arrow -shaped slot on the mounting bracket (B) and screw it
		through the opening to prevent further rotation. Hand-tighten the
		screw ( H).
	23.	Hand-tighten the remaining two clamp screws (J) to secure the
		mounting bracket ( B) to the swivel bracket (G).

Check all of the hardware for proper tightness and security. Do not over-

tighten the screws.