Brother PT-2030 Select Other, Margin, Too Long, Too High Check #, Digits, Entered, At Start&End

TROUBLESHOOTING

Message

Cause/Remedy

Select Other		The tape length set using the tape length setting is shorter
Margin! *		than the total length of the left and right margins applied for
		the "Large Margin" setting. Select a different margin setting.
Text		The length of the label to be printed using the text entered is
Too Long! *		longer than the length setting. Edit the text to fit within the set
		length or change the length setting.
Text		The text size is too large. Select a different size option.
Too High! *
Check # of		The number of digits entered in the bar code data does not
Digits		match the number of digits set in the bar code parameters.
Entered! *		Enter the correct number of digits.
Input A,B,C or D		The bar code data entered does not have the required start/
At Start&End! *		stop code (A, B, C, or D required at the beginning and end of
		the bar code data for the CODABAR protocol). Enter the bar
		code data correctly.
Maximum Of		There are already 5 bar codes entered in the text data when
5 Bar Codes		you try to enter a new bar code. You can only use up to five
Per Label! *		bar codes in each label.
Category Full!	*	The memory available for categories is full. To make more
		memory available, delete any unnecessary registered label
		files by highlighting the label file and pressing the OK key.
Installed tape is		Tape that is incompatible with the machine has been
not compatible with		installed. Use compatible tape.
this machine!	*
OK to Feed? *		Feeding tape after printing when [Chain print]
		is selected. Refer to ”Setting Margin” on page 45.

*Press any key to clear the error message.

58

Error Messages