Replacing the cassette ribbon

Two types of ribbons are available:

Ribbon Types		Brother Model
Correctable film ribbon	t 030	/ 1230
Nylon ribbon	i 1032

To replace the cassette ribbon:

1)Use [SPACE BAR] or Hto move the carrier to the centre of the platen,

2)Open the top cover.

3)Holding the cassette with both hands, lift the front of the cassette up and out.

4)Move the cassette towards the platen to remove it.

5)Turn the feed knob (on the left side of the cassette) counter-clockwise to tighten the ribbon in the new cassette.

6)Align the arrow on the cassette with the arrow on the cassette holder. Use both hands to ease the cassette

into the holder, back first.

7)Gently press down on the front of the cassette until it clicks into place.

8)Again turn the feed knob counter*clockwise to take up any slack.

9)Close the top cover.

10)Press _ +//to move the carrier to the previous position.

The amount of tape remaining can be checked ,through the viewing hole on the right side of the cassette.

Make sure to use only Brother-authorized cas- sette ribbons, correction tapes and cassette daisy wheels. Brother cannot be held responsible for difficulties caused by the use of unauthorized supplies.

Note;	Please	do not touch the keyboard	during	replacing the daisy	wheel, cassette J
	ribbon	or correction tape in order	to avoid	carrier movement.	I

-Page i0-