Using the hand scanner, Scanning a document

ストップ�

Using the hand scanner

ストップスタート画質

1 Press down the knob of the hand scanner, and pull out the scanner from the main unit. Then, turn it over.

	Knob
2 Press	画質 �	Resolution
	(Resolution) repeatedly

to select the desired resolution. ﾓｼﾞｽ = ﾁｲｻｲ [ ｶﾞｼﾂ ]
	ｻｲｽﾞ = A4ｾｾ [ ｾﾝﾀｸ ]
● Resolution types
ﾓｼﾞ=ﾌﾂｳ (Standard : For printed or typewritten originals
	with normal-sized characters)
ﾓｼﾞ=ﾁｲｻｲ (Fine : For originals with minute printing)
ｼｬｼﾝ (Photo : For originals containing photographs)

6 Press the hand scanner against the document, and move it slowly towards the direction of the arrow ( ).

●For the proper scanning speed for different resolution types, see “Scanning speed and memory capacity” on the bottom of this page.

●When the hand scanner is moved quickly, a beep will sounds and the following will be displayed.

ｽﾋﾟｰﾄﾞｶﾞﾊﾔｽｷﾞﾏｽ

7 After scanning the document, press	ストップ�
	(Stop).

●You will hear a beep, and the scanned document is stored in memory of the main unit. Only 1 page can be scanned.

8 To print the scanned document or to send it by fax, see the next page.

●If you make a mistake, press (Stop) to erase the content of the memory, then start from step 2.

Important:

●When you have completed scanning, the scanned document in memory will be automatically erased after 10 minutes.

●To reinsert the hand scanner into the main unit, turn the scanner over, and insert it into the main unit firmly.

3 Press 選択 (Select) repeatedly

to select the desired width.

●Scanning width types A4 (Within 208mm) B4 (Within 252mm)

ﾓｼﾞｽ = ﾁｲｻｲ [ ｶﾞｼﾂ ] ｻｲｽﾞ = A4ｾｾ [ ｾﾝﾀｸ ]

Scanning width

4 Place the scanning position and the

原稿左端 (Document’s left end) on the document.

(Document’s

left end)

(Scanning

position)

スタート�

5 Press (Start).

●When you hear a beep, you can start scanning.

(Bottom side)