Pentair 710 important safety instructions Setting up the Power Supply, At Least 10 Feet

Page 10

6

Setting up the Power Supply

WARNING —Risk of electrical shock or electrocution.

A ground fault current interrupter (GFCI) must be in place to protect your electric outlet . Failure to do so could create an electrical hazard which could result in death or serious injury to pool or spa users, installers, or others due to electrical shock, and may also cause damage to property.

The power supply MUST be placed a minimum distance of 10 feet away from the pool. Failure to do so could create an electrical hazard which could result in death or serious injury to pool or spa users, installers, or others due to electrical shock, and may also cause damage to property.

CAUTION — Never power the cleaner “ON” if it is not fully immersed in water.

This cleaner has an internal timer, which will automatically shut off the cleaner after 2 hours of operation. However, the Switch will remain in the “ON” position. To re-start the cleaner for another cycle, switch the Power Supply “OFF”, and then switch it back to the “ON” position and press the Reset Button. See Figure 1.

1.Place the Power Supply in a dry, sheltered area at least 10 feet away from the pool, see Figure 3. Since the Power Supply is water resistant, not water proof, it should not be left out in the rain or placed in puddles of water.

2.PlugthePowerSupplyCordintoa115V,threepronggroundedGFCIoutlet.Ifanoutletisnotcloseenough, a grounded 115V extension cord may be used to connect to the nearest outlet, see Figure 4.

Figure 4.

At Least 10 Feet

Figure 3.

(Remember to keep the Power Supply at least 10 feet away from the pool.)

Prowler™ 710 Installation and User’s Guide

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Prowler Customer Service Web siteContents Important Safety Precautions Important Notice Consumer Information and SafetySection Introduction Prowler 710 OverviewGeneral Features Introducing your new Prowler 710 Cleaner Section Set-upHow your Prowler 710 Cleaner works Setting up your Prowler 710 Cleaner Pool Cleaner with Floating Cable, FigureSetting up the Power Supply At Least 10 FeetPlacing the Cleaner into the Pool Adjusting the Timing Cycle Control should be adjusted accordinglyCleaning Motion in the Pool Removing the Cleaner from the PoolCleaning or Changing the Filter Bag In-Season Storage Off-Season StorageProwler 710 Installation and User’s Guide Section Troubleshooting Problem Corrective ActionThen repeat high pressure spraying into the Valve Housing Prowler 710 Installation and User’s Guide Section Replacement Parts Prowler 710 ModelReplacement Parts List for the Prowler 710 Model Power Supply Bottom LID AssyProwler 710 Installation and User’s Guide Prowler P12153 Rev. a 2/23/06
Top Page Image Contents