Pentair 710 important safety instructions Cleaning or Changing the Filter Bag

Page 14
Wire Frames
Long Side
Label
Figure 12.
Figure 14.

10

Cleaning or Changing the Filter Bag

1.MakesurethatthePowerSupplyisturned “OFF”andthatthecleaner'sFloatingCable isunpluggedfromthePowerSupply.Place the cleaner on its back on a non-abrasive surface and release the two Lock Tabs, (located on the sides of the unit), see Figure 11. Using your thumbs, push the Lock Tabs away from the center of the cleaner to unlock the Bottom Lid Assembly one Lock Tab at a time, see Figure 12. Remove the Bottom Lid Assembly, see Figure 13.

NOTE: Rest you cleaner on a non- abrasive surface (i.e. towel, doormat, etc.) to avoid scuffing and scratching your cleaner.

2.RemovetheFilterBagfromthebagsupport Wire Frames, see Figure 14. Turn the Filter Bag inside out, (the Fine Filter Bag has a soft felt surface on the inside), and wash off visible dirt using high pressure with a garden hose, or a faucet. Gently agitate the Bag in your hands to help removefineparticles.Continuewringing, cleaning and squeezing the Bag gently until rinse water is clear. Use of a washing machine, (cold water only), is recommended when visible dirt will not rinseoffbyothermethods.DONOTUSE DETERGENT or BLEACH! DO NOT MACHINEDRY!

Lock Tabs

Intake Valve Flaps

Figure 11.

Bottom Lid Assy.

Figure 13.

3. Turn the Filter Bag “right side out”, (felt

Bottom Lid Assy.

Filter Bag

surfaceontheinside),re-mounttheBagon

 

 

the Wire Frames making sure that the

Figure 15.

Figure 16.

 

 

LabelontheBagiscenteredononeofthe

 

 

long sides of the Bottom Lid Assembly, directly between the two U’s in the Wire Frames, see Figure 16. Pull the Bag toward the middle of each Wire Frame so that the Bag corners are snug against the corners of theWireFrame.TucktheexcessBagintotheU-shapedsectionoftheWireFramesasshowninFigure16.

4.Re-installtheBottomLidAssembly.MakesurethatneitherdebrisnortheFilterBagitselfinterfereswith complete closure of the Bottom Lid Assembly. A locking sound from each Lock Tab will be heard when lockedproperly!

Prowler™ 710 Installation and User’s Guide

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Prowler Customer Service Web siteContents Important Safety Precautions Important Notice Consumer Information and SafetySection Introduction Prowler 710 OverviewGeneral Features Introducing your new Prowler 710 Cleaner Section Set-upHow your Prowler 710 Cleaner works Setting up your Prowler 710 Cleaner Pool Cleaner with Floating Cable, FigureSetting up the Power Supply At Least 10 FeetPlacing the Cleaner into the Pool Adjusting the Timing Cycle Control should be adjusted accordinglyCleaning Motion in the Pool Removing the Cleaner from the PoolCleaning or Changing the Filter Bag In-Season Storage Off-Season StorageProwler 710 Installation and User’s Guide Section Troubleshooting Problem Corrective ActionThen repeat high pressure spraying into the Valve Housing Prowler 710 Installation and User’s Guide Section Replacement Parts Prowler 710 ModelReplacement Parts List for the Prowler 710 Model Power Supply Bottom LID AssyProwler 710 Installation and User’s Guide Prowler P12153 Rev. a 2/23/06
Top Page Image Contents