Pentair 710 Adjusting the Timing Cycle, Control should be adjusted accordingly

Page 12

8

Adjusting the Timing Cycle

The Time Control Dial located on the front panel of the Power Supply can be adjusted to allow more or less time between the cleaner's forward and reverse motion, see Figure 8.

Set your cleaner's Time Control Dial to 30 seconds. The goal is to have your cleaner move across your pool at its widest point, from one side to the other and wait at both sides for approximately 2 seconds before reversing. If this doesn't happen adjust the Time Control Dial accordingly.

NOTE: Turning the Time Control Dial clockwise will lengthen the time between reversals to a maximum time of 90 seconds. Conversely, turning the dial counter-clockwise will reduce the time between reversals.

Once the Time Control is set to your satisfaction, it does not need to be changed unless you use a different type of Filter Bag or there is an excessive amount of debris in your pool.

NOTE: The alternate Mesh Bag may cause the cleaner to cross your pool in less time and the Time

Control should be adjusted accordingly.

Turn Power Supply switch to the “ON” position, see Figure 9 €, then press the Reset Button, see Figure 9 .

2 1

Figure 7.

Figure 8.

Figure 9.

Prowler™ 710 Installation and User’s Guide

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Prowler Customer Service Web siteContents Important Safety Precautions Important Notice Consumer Information and SafetySection Introduction Prowler 710 OverviewGeneral Features Introducing your new Prowler 710 Cleaner Section Set-upHow your Prowler 710 Cleaner works Setting up your Prowler 710 Cleaner Pool Cleaner with Floating Cable, FigureSetting up the Power Supply At Least 10 FeetPlacing the Cleaner into the Pool Adjusting the Timing Cycle Control should be adjusted accordinglyCleaning Motion in the Pool Removing the Cleaner from the PoolCleaning or Changing the Filter Bag In-Season Storage Off-Season StorageProwler 710 Installation and User’s Guide Section Troubleshooting Problem Corrective ActionThen repeat high pressure spraying into the Valve Housing Prowler 710 Installation and User’s Guide Section Replacement Parts Prowler 710 ModelReplacement Parts List for the Prowler 710 Model Power Supply Bottom LID AssyProwler 710 Installation and User’s Guide Prowler P12153 Rev. a 2/23/06
Top Page Image Contents