Pentair Setting up your Prowler 710 Cleaner, Pool Cleaner with Floating Cable, Figure

Page 9

5

Setting up your Prowler™ 710 Cleaner

Your new cleaner consists of two main parts:

A. Power Supply (Transformer) with Two-Hour Automatic Shut-Off, Figure 1.

Fuse Holder	Forward/ReverseTimerControlDial
Power Supply Cord	Socket (for Floating Cable)
Power (ON/OFF) Switch	ResetButton

NOTE: The Power Supply appearance may vary and features may be located in different positions then what is shown above.

Rear view

Front view

6

	Figure 1.
B. Pool Cleaner with Floating Cable, Figure 2.
FloatingCable	Hydroscrub Tube* (Jet Nozzle)
FixedAxleHousing	JetValveHousing
TurningWheelAxleHousing	ScrewforValveExtension
Wheel(s)	ValveExtension(Port)
Handle

*NOTE: The Hydroscrub Tubes are hidden within the cleaner’s body.

1

2

4

5

63

Close Up

	7	8
	7	9
		9

Figure 2.

Prowler™ 710 Installation and User’s Guide

Image 9

Contents Prowler Web site Customer ServiceContents Important Notice Consumer Information and Safety Important Safety PrecautionsProwler 710 Overview Section IntroductionGeneral Features Section Set-up Introducing your new Prowler 710 CleanerHow your Prowler 710 Cleaner works Pool Cleaner with Floating Cable, Figure Setting up your Prowler 710 CleanerAt Least 10 Feet Setting up the Power SupplyPlacing the Cleaner into the Pool Control should be adjusted accordingly Adjusting the Timing CycleRemoving the Cleaner from the Pool Cleaning Motion in the PoolCleaning or Changing the Filter Bag Off-Season Storage In-Season StorageProwler 710 Installation and User’s Guide Problem Corrective Action Section TroubleshootingThen repeat high pressure spraying into the Valve Housing Prowler 710 Installation and User’s Guide Prowler 710 Model Section Replacement PartsPower Supply Bottom LID Assy Replacement Parts List for the Prowler 710 ModelProwler 710 Installation and User’s Guide Prowler P12153 Rev. a 2/23/06