Linksys WAPPOE manual Connection

Page 12

Chapter 2

Connection

3.Then connect the other end to the Ethernet port of your remotely located access point or other network device.

NOTE: If the plug of the Splitter’s Power cord does not fit into your network device, then use the included barrel jack adapter. Plug the Splitter’s Power cord into the jack end, and plug the other end of the barrel jack adapter into the Power port of your network device.

4.Connect the Kit’s power adapter to the Injector, and plug the other end into an electrical outlet or surge protector.

Congratulations! The installation of the Power Over Ethernet Kit is

complete.

	Power Over Ethernet Adapter Kit

Image 12

Contents Power Over Ethernet Adapter Kit Page About This Guide Icon DescriptionsOnline Resources Copyright and TrademarksAppendix a Specifications Appendix B Warranty Information Product OverviewConnection Appendix C Regulatory InformationProduct Overview IntroductionInjector Injector’s First Side PanelSplitter Injector’s LEDSplitter’s First Side Panel Splitter’s Second Side PanelSplitter’s LED Connection OverviewPower on a Device that Uses a Standard Power Adapter Power on a Device that Uses Inline Power Connection Appendix a Specifications WappoeSpecifications Appendix B Warranty Information Limited WarrantyObtaining Warranty Service Technical Support Safety Notices Appendix C Regulatory InformationFCC Statement Industry Canada Statement Avis d’Industry CanadaOdpadů nebo obchodu, kde jste produkt zakoupili Dansk Danish Miljøinformation for kunder i EU Producto Regulatory Information Regulatory Information Norsk Norwegian Miljøinformasjon for kunder i EU Regulatory Information 8021810B-JL