Linksys WAPPOE manual Power on a Device that Uses a Standard Power Adapter

Page 10

Chapter 2

Connection

Power on a Device that Uses a Standard

Power Adapter

Use the Injector and Splitter to power up a device that uses a standard power adapter. Follow these instructions:

1.Connect the Injector’s built-in Ethernet network cable to your router, switch, or other network device.

2.Connect the Kit’s included Ethernet network cable to the Injector’s Power & Data OUT port.

NOTE: If this cable is not long enough, then you can use your own Ethernet network cable.

3. Then connect the other end to the Splitter’s Power & Data IN port.

4.Connect the Splitter’s built-in Ethernet network cable to the Ethernet port of your remotely located access point or other network device.

5.Connect the Splitter’s Power cord to the Power port of your remotely located access point or other network device.

	Power Over Ethernet Adapter Kit

Image 10

Contents Power Over Ethernet Adapter Kit Page Online Resources About This GuideIcon Descriptions Copyright and TrademarksConnection Appendix a Specifications Appendix B Warranty InformationProduct Overview Appendix C Regulatory InformationInjector Product OverviewIntroduction Injector’s First Side PanelSplitter Injector’s LEDSplitter’s First Side Panel Splitter’s Second Side PanelSplitter’s LED Connection OverviewPower on a Device that Uses a Standard Power Adapter Power on a Device that Uses Inline Power Connection Appendix a Specifications WappoeSpecifications Appendix B Warranty Information Limited WarrantyObtaining Warranty Service Technical Support Appendix C Regulatory Information Safety NoticesFCC Statement Industry Canada Statement Avis d’Industry CanadaOdpadů nebo obchodu, kde jste produkt zakoupili Dansk Danish Miljøinformation for kunder i EU Producto Regulatory Information Regulatory Information Norsk Norwegian Miljøinformasjon for kunder i EU Regulatory Information 8021810B-JL