Linksys WAPPOE manual Power on a Device that Uses Inline Power

Page 11

Connection

Chapter 2

NOTE: If the plug of the Splitter’s Power cord does not fit into your network device, then use the included barrel jack adapter. Plug the Splitter’s Power cord into the jack end, and plug the other end of the barrel jack adapter into the Power port of your network device.

6.Connect the Kit’s power adapter to the Injector, and plug the other end into an electrical outlet or surge protector.

Congratulations! The installation of the Power Over Ethernet Kit is

complete.

Power on a Device that Uses Inline Power

Use only the Injector to power up a device that supports inline power. Follow these instructions:

1.Connect the Injector’s built-in Ethernet network cable to your router, switch, or other network device.

2.Connect the Kit’s included Ethernet network cable to the Injector’s Power & Data OUT port.

Power Over Ethernet Adapter Kit

Image 11

Contents Power Over Ethernet Adapter Kit Page Copyright and Trademarks About This GuideIcon Descriptions Online ResourcesAppendix C Regulatory Information Appendix a Specifications Appendix B Warranty InformationProduct Overview ConnectionInjector’s First Side Panel Product OverviewIntroduction InjectorInjector’s LED SplitterSplitter’s Second Side Panel Splitter’s First Side PanelSplitter’s LED Overview ConnectionPower on a Device that Uses a Standard Power Adapter Power on a Device that Uses Inline Power Connection Wappoe Appendix a SpecificationsSpecifications Limited Warranty Appendix B Warranty InformationObtaining Warranty Service Technical Support FCC Statement Safety NoticesAppendix C Regulatory Information Avis d’Industry Canada Industry Canada StatementOdpadů nebo obchodu, kde jste produkt zakoupili Dansk Danish Miljøinformation for kunder i EU Producto Regulatory Information Regulatory Information Norsk Norwegian Miljøinformasjon for kunder i EU Regulatory Information 8021810B-JL