Linksys EtherFast® Series
Connecting to an Ethernet or Fast Ethenet Network
1.Attach one end of an Ethernet cable into the USB Network Adapter’s LAN 10/100 port.
2.Plug the other end of the cable into an Ethernet or Fast Ethernet hub, switch, or router. If you plan to use both 10BaseT and 100Mbps network segments on the same network, you'll need a
Your computer is now connected to your Ethernet or Fast Ethernet net- work.
•If your computer runs Windows 98, go to the next page now for driver installation instructions.
•If your computer runs Windows Millennium, go to the Windows Millennium Installation & Steup section now.
•If your computer runs Windows 2000, go to the Windows 2000 Installation & Steup section now.
10/100 USB Network Adapter
Windows 98 Installation & Setup
Overview
After physically installing the 10/100 USB Network Adapter in your comput- er, follow these instructions to install the network driver. The installation pro- cedure for the network driver will vary slightly depending on which version of Windows 98 you are using, and on your current system configuration. If at any time during the installation you encounter problems, consult the Troubleshooting section.
Installing the USB Network Adapter’s Driver
After installing the EtherFast 10/100 USB Network Adapter, follow the instructions below to install the adapter’s software into your Windows 98 computer.
1.If you haven’t already, start up your computer.
2.Windows 98 will automatically detect the presence of the LINKSYS USB Adapter hardware in your computer.
3.Slide the Linksys Driver Disk into your floppy drive while the Add New Hardware Wizard window is visible. Click Next.
7 | 8 |