Linksys WUSB11 manual Hardware Detection for Windows 98SE, Me

Page 11

Instant WirelessTM Series

Hardware Detection for Windows 98SE, Me, and 2000

After the Wireless USB Network Adapter has been physically connected to your computer, Windows will detect the new hardware. You may see the screen in Figure 5-7. Click on the Yes button to continue or the No button to stop the installation.

Figure 5-7

In most cases, Windows will then automatically copy all of the files needed for networking. If Windows asks you for the files, and D is your computer’s CD- ROM drive, they may be located at: D:\Drives

These files may also be located at C:\windows\options\cabs. Check with your operating system’s user guide for the exact location.

Note to Windows 2000 Users: You may be prompted at this time that a digital signature has not been found; this is normal. See Figure 5-7. The WUSB11 has been verified to run on Windows 2000. Click Yes to continue, and then click the Finish button to end the hardware detection process.

Important for Windows XP users: After the Wireless USB Network Adapter has been physically connected to your computer, Windows will detect the new hardware. Proceed to Chapter 6: Installation and Configuration of the USB Adapter for Windows XP.

Wireless USB Network Adapter

Chapter 6: Installation and Configuration of the USB Drivers for Windows XP

After attaching the Wireless USB Network Adapter to your computer, you will install the network driver.

Important for Windows XP users: Do NOT run the Wireless Network Adapter Setup Wizard. If the Setup Wizard runs automatical- ly after the Setup Wizard CD has been inserted, click the Exit tab.

1.Windows XP will automatically detect the presence of the Wireless USB Network Adapter in your computer. Insert the Setup Wizard CD into your CD-ROM Drive. Click the radio button next to Install from a list or spe- cific location (Advanced). Then click the Next button to continue.

Figure 6-1

15

16

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Wireless USB Network Adapter UG-WUSB11 ver .6-032002 BW Table of Contents Introduction Instant WirelessTM USB Network AdapterFeatures Package ContentsRoaming Planning Your Wireless NetworkWireless USB Network Adapter’s Port and LEDs Network TopologyPower Software and Driver Installation for Windows 98SE, Me, Instant WirelessTM Series USB Cabling USB IconUsing the Wireless USB Network Adapter’s Wall Mount Removing the Wireless USB Network AdapterHardware Detection for Windows 98SE, Me, Windows XP Wireless Zero Configuration Instant Broadband Series Installing the Network Protocols for Windows 98SE and Me Installing Network ProtocolsConfiguring the Wireless USB Network Adapter Instant WirelessTM Series Instant WirelessTM Series Frequently Asked Questions Appendix a TroubleshootingCommon Problems and Solutions What is BSS ID? Appendix B Glossary Instant WirelessTM Series WEP Appendix C SpecificationsAppendix D Environmental Appendix E Warranty InformationAppendix F Contact Information Copyright 2002 Linksys, All Rights Reserved
Top Page Image Contents