Linksys WPC55AG manual Appendix B Glossary

Page 21

Appendix B: Glossary

802.11a - One of the IEEE standards for wireless networking hardware. Products that adhere to a specific IEEE standard will work with each other, even if they are manufactured by different companies. It specifies a maximum data transfer rate of 54Mbps and an operating frequency of 5GHz. The 802.11a standard uses the Orthogonal Frequency Division Multiplexing (OFDM) trans- mission method. Additionally, the 802.11a standard supports 802.11 features such as WEP encryption for security.

802.11b - One of the IEEE standards for wireless networking hardware. Products that adhere to a specific IEEE standard will work with each other, even if they are manufactured by different companies. The 802.11b standard specifies a maximum data transfer rate of 11Mbps, an operating frequency of 2.4GHz, and WEP encryption for security. 802.11b networks are also referred to as Wi-Fi networks.

802.11g - A proposed, but as yet unratified extension of the IEEE 802.11 stan- dard for wireless networking hardware. The draft 802.11g specifications used by Linksys specify a maximum data transfer rate of 54Mbps using OFDM modulation, an operating frequency of 2.4GHz, backward compatibility with IEEE 802.11b devices, and WEP encryption for security.

Adapter - Printed circuit board that plugs into a PC to add to capabilities or connectivity to a PC. In a networked environment, a network interface card is the typical adapter that allows the PC or server to connect to the intranet and/or Internet.

Ad-hoc Network - An ad-hoc network is a group of computers, each with a wireless adapter, connected as an independent 802.11 wireless LAN. Ad-hoc wireless computers operate on a peer-to-peer basis, communicating directly with each other without the use of an access point.

Bandwidth - The transmission capacity of a given facility, in terms of how much data the facility can transmit in a fixed amount of time; expressed in bits per second (bps).

Bit - A binary digit. The value—0 or 1—used in the binary numbering system. Also, the smallest form of data.

Cardbus - A high-speed peripherals interface for notebook PCs that delivers 32-bit performance based on PCI bus architecture.

CSMA/CA (Carrier Sense Multiple Access/Collision Avoidance) - In local area networking, this is the CSMA technique that combines slotted time-divi- sion multiplexing with carrier sense multiple access/collision detection (CSMA/CD) to avoid having collisions occur a second time.

CTS (Clear To Send) - An RS-232 signal sent from the receiving station to the transmitting station that indicates it is ready to accept data.

Default Gateway - The routing device used to forward all traffic that is not addressed to a station within the local subnet.

DHCP (Dynamic Host Configuration Protocol) - A protocol that lets network administrators manage centrally and automate the assignment of Internet Protocol (IP) addresses in an organization's network. Using the Internet's set of protocol (TCP/IP), each machine that can connect to the Internet needs a unique IP address. When an organization sets up its computer users with a con- nection to the Internet, an IP address must be assigned to each machine. Without DHCP, the IP address must be entered manually at each computer and, if computers move to another location in another part of the network, a new IP address must be entered. DHCP lets a network administrator supervise and dis- tribute IP addresses from a central point and automatically sends a new IP address when a computer is plugged into a different place in the network.

DHCP uses the concept of a “lease” or amount of time that a given IP address will be valid for a computer. The lease time can vary depending on how long a user is likely to require the Internet connection at a particular location. It's espe- cially useful in education and other environments where users change fre- quently. Using very short leases, DHCP can dynamically reconfigure networks in which there are more computers than there are available IP addresses.

DHCP supports static addresses for computers containing Web servers that need a permanent IP address.

DNS - The domain name system (DNS) is the way that Internet domain name are located and translated into Internet Protocol (IP) addresses. A domain name is a meaningful and easy-to-remember “handle” for an Internet address.

34

35

Image 21
Contents Dual-Band Wireless A+G Copyright & Trademarks Table of Contents Dual-Band Wireless A+G Notebook Adapter Common Problems and Solutions Frequently Asked QuestionsFeatures IntroductionPlanning Your Wireless Network Ad-Hoc versus Infrastructure ModeNetwork Topology Dual-Band Wireless A+G Notebook Adapter’s LEDs Hardware InstallationOverview Windows XP Wireless Zero Configuration Driver Installation for Windows XPInstallation and Configuration for Windows 98, Me, Software Installation for Windows 98, Me,\setup.exe where D is the letter of your CD-ROM drive Page Mode Proceed to the next section, Hardware InstallationStarting the Wlan Monitor Using the Wlan Monitor for Windows 98, Me,Wireless Network Status TCP/IP SettingLink Information Site Information Site SurveyProfile Information ProfilesCreating a New Profile Page Select G-Only Mode Mixed ModeLeap Authentication Appendix a Troubleshooting Common Problems and SolutionsFrequently Asked Questions What Ieee 802.11b features are supported? Appendix B Glossary Page Page Page Environmental Appendix C SpecificationsAppendix E Contact Information Appendix D Warranty InformationSales Information Web FTP SiteCopyright 2003 Cisco Systems, Inc. All Rights Reserved

WPC55AG specifications

The Linksys WPC55AG is a versatile and robust wireless adapter designed to enhance connectivity for laptops and desktop computers. This device stands out with its combination of dual-band connectivity, supporting both 2.4GHz and 5GHz frequencies, making it an excellent choice for users looking to achieve faster speeds and reduced interference. The capability to operate on two different frequencies allows for flexibility in network environments, catering to the varying needs of users.

One of the main features of the WPC55AG is its support for both 802.11g and 802.11a wireless standards, which means it can connect to a wide range of access points and routers. The device can provide wireless speeds up to 54Mbps on the 802.11g band and even higher when operating on the 802.11a band. This ensures a reliable connection for various applications such as video streaming, online gaming, and large file transfers.

The WPC55AG also incorporates advanced security protocols, including Wired Equivalent Privacy (WEP), Wi-Fi Protected Access (WPA), and WPA2. These security features help to safeguard users' networks from unauthorized access, ensuring a secure browsing experience whether at home or in public environments.

Installation of the Linksys WPC55AG is straightforward, thanks to its user-friendly setup wizard. The card is compatible with a variety of operating systems, including Windows and Mac OS, ensuring that a wide range of users can benefit from its capabilities. With its PCI card form factor, this wireless adapter can easily be installed in most computers, providing a stable connection that surpasses that of many built-in wireless solutions.

In addition to its impressive technical features, the Linksys WPC55AG is notable for its durability and reliability. Designed for long-term use, this adapter boasts a sleek design that complements modern computing setups while maintaining functionality. With ongoing updates and support from Linksys, users can ensure that their devices operate at peak performance.

In conclusion, the Linksys WPC55AG is an excellent choice for individuals looking to enhance their wireless connectivity. Its dual-band capabilities, extensive range of compatible standards, robust security features, and ease of installation make it a go-to option for both casual users and gaming enthusiasts alike. Whether at home or on-the-go, this wireless adapter provides the performance and reliability that users demand.