Create a Tunnel Through the Web-Based Utility

ADSL Gateway with 4-Port Switch

Step 5: Create a Tunnel Through the Web-Based Utility

1.Open your web browser, and enter 192.168.1.1 in the Address field. Press the Enter key.

2.When the User name and Password field appears, enter the default user name and password admin. Press the Enter key.

3.From the Setup tab, click the VPN tab.

4.From the VPN tab, select the tunnel you wish to create in the Select Tunnel Entry drop-down box. Then click Enabled. Enter the name of the tunnel in the Tunnel Name field. This is to allow you to identify multiple tunnels and does not have to match the name used at the other end of the tunnel.

5.Enter the IP Address and Subnet Mask of the local VPN Router in the Local Secure Group fields. To allow access to the entire IP subnet, enter 0 for the last set of IP Addresses. (e.g. 192.168.1.0).

6.Enter the IP Address and Subnet Mask of the VPN device at the other end of the tunnel (the remote VPN Router or device with which you wish to communicate) in the Remote Security Router fields.

7.Select fromtwo different types of encryption: DES or 3DES (3DES being more secure). You may choose either of these, but it must be the same type of encryption that is being used by the VPN device at the other end of the tunnel. Or, you may choose not to encrypt by selecting Disable.

8.Select from two types of authentication: MD5 and SHA (SHA being more secure). As with encryption, either of these may be selected, provided that the VPN device at the other end of the tunnel is using the same type of authentication. Or, both ends of the tunnel may choose to Disable authentication.

9.Select the Key Management. Select Auto (IKE) and enter a series of numbers or letters in the Pre-shared Key field. Check the box next to PFS (Perfect Forward Secrecy) to ensure that the initial key exchange and IKE proposals are secure. You may use any combination of up to 24 numbers or letters in this field. No special characters or spaces are allowed. In the Key Lifetime field, you may optionally select to have the key expire at the end of a time period of your choosing. Enter the number of seconds you’d like the key to be useful, or leave it blank for the key to last indefinitely.

10.Click the Save Settings button to save these changes.

Your tunnel should now be established.

Appendix B: Configuring IPSec between a Windows 2000 or XP Computer and the Gateway

Figure B-28: VPN Tab

How to Establish a Secure IPSec Tunnel