Airlink101 APSUSB211 user manual

Page 10

Step 5 Click on the Print Test link and click the Test button. The Print Server will perform a low-level print test, bypassing the operating system layer.

Note: Your printer should print out a test page. If not, verify that the printer is powered on and all cables are securely connected and try again. If the printer still fails to print a test page, please check the printer compatibility list on our web site at www.airlink101.com for a list of compatible printers. If your printer is not on the list, it may not be compatible with the Print Server.

Step 6 Once the printer successfully prints out a test page, you may close the web browser and proceed to the next section.

9

Image 10
Contents Port USB 2.0 Print Server Model # APSUSB211 User’s Manual Table of Contents Introduction Package ContentsSystem Requirements Hardware Installation Connecting the Print ServerInstalling PS Utility Click Next Click Yes Click Finish Configuring Network Setting Click OK Verifying Network Connection Page Running PS Wizard Click Next Page Click on Start, Settings, Printers and Faxes Performing Operating System Print TestPage Using the PS Utility Using the Web Configuration Utility Click on the Show Web Setup button in PS UtilityHome Setup Wizard Page Page Page Click Yes to save the settings, No to cancel the settings Change IP Address Printer Information Print Test Factory Reset Firmware Upgrade About Using Rendezvous Printing in Mac OSPage Page Appendix Technical Support