Airlink101 APSUSB211 user manual Hardware Installation, Connecting the Print Server

Page 4

2 Hardware Installation

2.1 Connecting the Print Server

Warning: Only a USB printer may be connected to the USB port of the Print Server. Connecting any other USB device to the Print Server may damage the Print Server. Do not plug the power cord to the Print Server until you have reached Step 4 of this section.

Note: Before proceeding with the steps below, please verify that the printer operates properly on each of the computer that will be printing through the Print Server.

Step 1Connect one end of the Ethernet cable to the RJ-45 port of the Print Server and attach the other end of the cable to a router.

Step 2 Make sure the printer is powered OFF, then connect one end of the USB cable to the USB port of the Print Server and attach the other end of the cable to the USB port of the printer.

Step 3 Power ON the printer.

Step 4 Plug one end of the power cord into the Print Server and the other end into an electrical outlet.

3

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Port USB 2.0 Print Server Model # APSUSB211 User’s Manual Table of Contents Introduction Package ContentsSystem Requirements Hardware Installation Connecting the Print ServerInstalling PS Utility Click Next Click Yes Click Finish Configuring Network Setting Click OK Verifying Network Connection Page Running PS Wizard Click Next Page Click on Start, Settings, Printers and Faxes Performing Operating System Print TestPage Using the PS Utility Using the Web Configuration Utility Click on the Show Web Setup button in PS UtilityHome Setup Wizard Page Page Page Click Yes to save the settings, No to cancel the settings Change IP Address Printer Information Print Test Factory Reset Firmware Upgrade About Using Rendezvous Printing in Mac OSPage Page Appendix Technical Support
Top Page Image Contents