Airlink101 APSUSB211 user manual Configuring Network Setting

Page 7

4. Configuring Network Setting

Before configuring the Print Server’s network setting, please take note of your computer’s TCP/IP setting.

Step 1 Click on Start, Run, and type command (for Windows 95/98/ME) or cmd (for Windows 2000/XP) and click OK.

Step 2 At the command prompt, type ipconfig and press Enter.

Step 3 Write down the information for the IP Address, Subnet Mask, and Default Gateway. You will need these information later.

Step 4 Run the PS Utility by going to Start, (All) Programs, PS-Utility,PS-Utility v3.00.

Step 5 Make sure the Print Server is listed under the Device Name and click on Change IP Address.

6

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Port USB 2.0 Print Server Model # APSUSB211 User’s Manual Table of Contents Introduction Package ContentsSystem Requirements Connecting the Print Server Hardware InstallationInstalling PS Utility Click Next Click Yes Click Finish Configuring Network Setting Click OK Verifying Network Connection Page Running PS Wizard Click Next Page Performing Operating System Print Test Click on Start, Settings, Printers and FaxesPage Using the PS Utility Click on the Show Web Setup button in PS Utility Using the Web Configuration UtilityHome Setup Wizard Page Page Page Click Yes to save the settings, No to cancel the settings Change IP Address Printer Information Print Test Factory Reset Firmware Upgrade About Printing in Mac OS Using RendezvousPage Page Technical Support Appendix
Top Page Image Contents